Free English LOST VAPE THELEMA 80W POD MOD (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD LOST VAPE THELEMA 80W POD MOD (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
What are the technical specifications for the LOST VAPE THELEMA 80W POD MOD?
The technical specifications are as follows:
Dimension: 101mm x 35.3mm x 29.4mm
Weight: 152g
Battery: 3000 mAh Built-in Lithium Battery
Battery Voltage: 3.0V-4.2V
Output Voltage: 0.8V-4.0V
Power Range: 5-80W
Current Range: 0.3A-22A
Coil Resistance Supported Range: 0.12O-5.0O
Screen Pixel: 0.96 inch 108*217
Body Material: Zinc Alloy
How do I turn the LOST VAPE THELEMA 80W POD MOD on or off?
To turn the device on or off, press the Fire button 5 times consistently within 2 seconds.
How do I adjust the wattage on the LOST VAPE THELEMA 80W POD MOD?
You can adjust the wattage by using the Up (+) and Down (-) buttons once the device is powered on.
How do I lock and unlock the wattage on the LOST VAPE THELEMA 80W POD MOD?
Press and hold the Up (+) and Down (-) buttons at the same time to Lock and Unlock the wattage setting.
How do I change the screen color on the LOST VAPE THELEMA 80W POD MOD?
Press and hold the Fire and Up (+) button at the same time to change the color theme.
How do I reset the puff time and puff count on the LOST VAPE THELEMA 80W POD MOD?
Press and hold the Fire and Down (-) button at the same time to reset the puff time and puff count.
How do I charge the LOST VAPE THELEMA 80W POD MOD?
Connect the micro USB cable to a power source. The battery icon will begin to animate and stop animating once fully charged (Battery Voltage > 4.18V).
How do I fill the LOST VAPE THELEMA 80W POD MOD with e-liquid?
Follow these steps:
1. Unplug the e-liquid refilling plug.
2. Refill the pod from the e-liquid filling slot.
3. Seal the pod after filling.
How do I replace the coil in the LOST VAPE THELEMA 80W POD MOD?
Follow these steps:
1. Take out the pod.
2. Take out the coil.
3. Unscrew the AFC ring.
4. Screw the new coil back onto the AFC ring.
5. Push the coil back into the pod.
6. Put the pod back into the device.
What are the troubleshooting steps for warnings on the LOST VAPE THELEMA 80W POD MOD?
Check Atomizer: The device will show “Check Atomizer” if no atomizer is detected or the resistance is higher than 5O.
Short Circuit: If the atomizer resistance is lower than 0.12O, the screen displays “ShortCircuit” once you press the Fire button.
Too Hot: The device will shut down and display “TOO HOT” once the temperature of the internal board is higher than 75°C. You can use the device again when the temperature is back to 60°C.
Low Battery: Output will automatically cut off and the screen will show “Low Battery”. This means the battery voltage is below 3.2V before use or lower than 2.85V when you are using; this will continue to display for a few seconds after attempting to fire the device. Users should remove and replace the battery.
Over 10s: Output will automatically cut off and the screen shows “Over 10s” when you fire for over 10s continuously.
CLICK HERE TO DOWNLOAD LOST VAPE THELEMA 80W POD MOD (01) PDF DOCUMENT