Free English LOST VAPE URSA POCKET (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD LOST VAPE URSA POCKET (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
How do you install the LOST VAPE URSA POCKET pod?
Step 1: Take out the pod from the device.
Step 2: Fill e-liquid through the filling port.
Step 3: Put the pod back into the device.
How do you operate the LOST VAPE URSA POCKET?
1. Power On/Off: Press the fire button 5 times in 2 seconds.
2. Vaping: Auto draw or press the fire button.
3. Lock/Unlock: Press the fire button 3 times continuously to lock or unlock the fire button. In the locked state, the device can still be vaped by auto draw.
4. Power Adjustment: Press the UP or DOWN button to adjust the power. When the screen is locked, long press the UP or DOWN button to enter the main interface.
5. Puff Clear: Press the fire button and DOWN button at the same time to clear the puff.
6. Charging: Plug in the Type-C cable to charge the device.
What are the warning messages for the LOST VAPE URSA POCKET?
| WARNING | INSTRUCTION |
|---|---|
| Check Atomizer | Pod not detected, or short circuit, or resistance too low/high. |
| Low Battery | Battery voltage is lower than 3.2V, please charge the device. |
| Too Hot | PCBA temperature is over 68℃, the device will stop working and resume after cooling down. |
| Over 10S | Vaping time over 10 seconds. |
What are the specifications of the LOST VAPE URSA POCKET?
| Parameter | Value |
|---|---|
| Dimension | 86*46.2*19mm |
| Net Weight | 88g |
| Pod Capacity | 2.5ml |
| Battery | 1200mAh |
| Battery Voltage | 3.2V-4.2V |
| Power Range | 5-30W |
| Body Material | Aluminum Alloy & Plastic |
| Charging Voltage | 5V/1A |
| Type-C Cable | Supports 5V/2A charger |
How do you fill the LOST VAPE URSA POCKET with E-liquid?
1. Pull out the pod from the device.
2. Open the stopper and fill with E-liquid.
3. Close the stopper firmly and put the pod back into the device.
4. Please wait 5 minutes after filling E-liquid for the first time, allowing the E-liquid to fully saturate the coil.
CLICK HERE TO DOWNLOAD LOST VAPE URSA POCKET (01) PDF DOCUMENT