Free English LOST VAPE URSA CAP POD KIT (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD LOST VAPE URSA CAP POD KIT (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
What are the charging indications for the LOST VAPE URSA CAP POD KIT?
The LED indicator shows the battery status as follows when connected to a power supply:
Red Light: Less than 3.7V
Blue Light: 3.7V to 3.9V
Green Light: Greater than 3.9V
Stay Green: Fully charged (about 4.2V)
What do the LED flash warnings mean on the LOST VAPE URSA CAP POD KIT?
Low Battery: The LED indicator will flash red 5 times and output will automatically cut off when the battery voltage is below or equal to 3.3V before using, or lower than 2.9V when vaping.
Open Circuit: The LED indicator will flash 3 times when the atomizer is not connected, the heating coil of the atomizer is broken, or the resistance is greater than 2 ohm.
Short Circuit: The LED indicator will flash white 3 times and no power output will occur when a short circuit happens or the resistance is lower than 0.5 ohm.
Over 10s: The LED indicator will flash 8 times and the output will be automatically cut off when you vape over 10 seconds continuously.
How do I fill the LOST VAPE URSA CAP POD KIT with e-liquid?
Step 1. Take out the pod from the device.
Step 2. Open the e-liquid refilling plug.
Step 3. Refill the pod through the filling slot.
Step 4. Seal the plug after filling.
Step 5. Put the pod back into the device.
What should I consider when using a new coil with the LOST VAPE URSA CAP POD KIT?
It is essential to prime a new coil. You should fill the tank with e-liquid and leave it to stand for at least 5 minutes before vaping. This allows the cotton inside the new coil to absorb plenty of e-liquid, ensuring the best performance.
What are the technical specifications of the LOST VAPE URSA CAP POD KIT?
The technical specifications are as follows:
Dimension: 18.4mm x 31.4mm x 92.0mm
Net Weight: 50.5g ± 3g
Pod Capacity: 2.5ml / 2ml
Battery Capacity: 1000mAh (built-in)
Battery Voltage: 3.3V – 4.2V
Power Range: 9W – 25W
Charging Voltage: 5V/1A
Type-C Cable Support: 5V/2A Charger
Body Material: Plastic
CLICK HERE TO DOWNLOAD LOST VAPE URSA CAP POD KIT (01) PDF DOCUMENT