LOST VAPE BACK TO BASIC MOD (01) PDF Document

The technical specifications are as follows:

Press the fire button 5 times consistently to turn the LOST VAPE BACK TO BASIC MOD on. To turn it off, press the fire button 5 times. The screen will darken in 10s without any operations and it will turn off in another 10s.

Turn on the device. Press the Select button to enter the mode selection. Use the up (+) or down (-) button to cycle through the available modes (POWER/VOLTAGE/TC-SS/TC-Ni/TC-Ti). Press the Select button again to confirm your choice.

Use the up (+) and down (-) buttons to adjust the wattage or voltage under POWER or VOLTAGE mode respectively to the desired value. Press the Select button to confirm.

The temperature can be adjusted under SS/Ni/Ti mode during operation to prevent the coil being too hot regardless of fluid, wicking, or airflow. To set it, follow these steps:

1. Enter SS/Ni/Ti mode. Use the up (+) and down (-) buttons to change the temperature value between 100°C-300°C/200°F-600°F.

2. Press the Select button to confirm.

Press and hold the Select button and the up (+) button at the same time to lock or unlock the wattage setting on the LOST VAPE BACK TO BASIC MOD.

Press and hold the Select button and the down (-) button at the same time to reset the puff time and puff count on the LOST VAPE BACK TO BASIC MOD.

Press and hold the Select button for 2 seconds to change the screen color theme on the LOST VAPE BACK TO BASIC MOD.

The LOST VAPE BACK TO BASIC MOD has a built-in DC 5V TYPE-C port. Connect the USB-C cable to a power source and the battery icon will begin to animate and stop animating once fully charged.

If you see Check Atomizer, the device is telling you that no atomizer is detected, or the atomizer resistance is higher than 3Ω.

If you see Short Circuit, the atomizer resistance is lower than 0.1Ω, and the screen displays Short Circuit once you press the Fire button.

The device will shut down and display Too Hot once the temperature of the internal board is higher than 80°C. You can use the device again when the temperature is back to 60°C.

The Low Battery message means the battery voltage is below 3.2V before use or lower than 3.0V when you are using the device. The message will continue to display for a few seconds before attempting to fire the device. Users should remove and replace the battery.

The LOST VAPE BACK TO BASIC MOD will automatically cut off and show Over 10s when you fire the device for over 10s continuously.