LOST VAPE CENTAURUS M100 BOX MOD (01) PDF Document

The LOST VAPE CENTAURUS M100 BOX MOD features the following specifications:

The device utilizes a toggle switch for power management.

To turn the device ON: Push the Switch Button to the right.

To turn the device OFF: Push the Switch Button to the left.

To enter the power adjustment mode, turn the 360 degree Rotation Button. Turning the button clockwise will increase the power in the following incremental steps:

5W to 39W: 1W increments

40W to 98W: 2W increments

The device allows for cyclical adjustment between the minimum of 5W and the maximum of 100W.

To lock or unlock the wattage adjustment function, press the Fire button 3 times consistently within 2 seconds. Please note that the Fire button will still function for vaping even when the wattage adjustment is locked.

Step 1: Ensure the wattage adjustment function is in the unlocked state.

Step 2: Press the Fire button 5 times within 2 seconds to toggle between Normal Mode and RDA DIY Mode.

The LED indicators on the LOST VAPE CENTAURUS M100 BOX MOD will flash while vaping or charging to indicate the remaining battery capacity:

0% to 20% capacity

20% to 40% capacity

40% to 60% capacity

60% to 80% capacity

80% to 100% capacity

While the device is in the power-off state, press the Fire Button and then turn on the Switch Button to reset the puff count. The peak display for the puff count is 9999.

It is essential to prime a new coil to avoid dry burning. Fill your tank with e-liquid and leave it to stand for at least 5 minutes before vaping. This allows the cotton inside the new coil to absorb enough e-liquid for the first use.

This message indicates the battery level is at 0%. The output will automatically turn off, and the indicator will flash 3 times with a purple light. You must change or charge the battery to continue use.

This warning means no atomizer is detected or the atomizer resistance is higher than 3 ohms. When the fire button is pressed, the screen shows “Check Atomizer” and the indicator flashes 3 times with a purple light. Ensure your tank is properly connected and the coil is within the supported resistance range.

A “Short Circuit” message means the atomizer resistance is lower than 0.08 ohms. The indicator will flash 3 times with a purple light. Check your coil and atomizer for any issues or improper installation.

The device will shut down if the internal board temperature exceeds 85 degrees Celsius. The screen will display “Too Hot” and the indicator will flash 3 times with a purple light. You can resume using the device once the temperature has dropped back to 65 degrees Celsius.

If you vape continuously for over 10 seconds, the output automatically shuts off to protect the device. The screen will show “Over 10s” and the indicator will flash purple 3 times.