DYSON AIRWRAP (01) PDF MANUAL

DYSON AIRWRAP (01) PDF SUMMARY:

How do I get started with the Dyson Airwrap?

Power on/off with cold shot using the sliding switch, which sets your style. You can control the airflow with 3 airflow speeds and control the temperature with 2 heat settings plus a cold setting to finish your style.

Where is the power button located?

The power button is located in the middle of the handle. It is a slider button that pushes upwards and downwards.

Where is the temperature control button located?

The temperature control button is located on the back, right-hand side of the handle.

Where is the airflow control button located?

The airflow control button is located on the back, left-hand side of the handle.

How do I connect an attachment?

Turn the attachment into the main body until it fits securely.

How do I change attachments?

To change the attachment, pull down on the switch to release it.

What part of the attachment do I hold when handling hot attachments?

Hold the attachment only in the area indicated.

How do I use the Coanda smoothing dryer for pre-styling?

Before curling, pre-dry the hair until almost dry using the Coanda smoothing dryer, which comes with two modes: drying and smoothing. Use the cool tip to switch between the two modes.

How do I curl my hair using the Airwrap barrel?

1. Take a section of hair and bring the barrel towards the tips. Hair will start to wrap around the barrel.
2. Move the styler towards the head, with no need to twist. Hold for 15 seconds or until dry.
3. Press the cold shot for 5-10 seconds to set the curl. Switch off to release. To change the curl direction, rotate the cool tip.

How do I smooth my hair using smoothing brushes?

1. Rough-dry hair with the Coanda smoothing dryer.
2. Use the Smoothing brush to brush from root to tip. For volume, face bristles outwards. Turn the brush inwards at the ends to create shape.

How do I use the Coanda smoothing dryer for smoothing?

Rotate the cool tip to select Smoothing mode. Press against the hair to switch airflow direction. Position the contact bar against the head until you hear a click and hair attracts. Run from root to tip to hide flyaways.

How do I hide flyaways?

Use on dry hair to hide flyaways. Position against hair until it attracts, then slowly run down to tips. For use on dry and straight hair.

When does the filter need to be cleaned?

The filter must be cleaned when the white LED starts flashing.

How do I clean the filter?

1. Ensure that you unplug your appliance from the main electricity supply and allow it to cool down before cleaning your filter.
2. Slide the filter cleaning brush over the cable and onto the filter cage.
3. Using a rotating action, clean the filter cage thoroughly. Remove the filter cleaning brush.
4. Hold the handle of your appliance and pull the filter cage downwards, onto the cable.
5. Gently pull open the filter cage and slide it off the cable.
6. Wash the filter cage under a warm, running tap.
7. Shake the filter cage to remove the majority of the excess water, then leave to dry naturally.
8. Using a rotating and up and down action, clean the filter mesh with the filter cleaning brush until all the debris has been removed. Do not use water or chemicals to clean the filter mesh.
9. Gently pull the filter cage open and slide it onto the cable.
10. Slide the filter cage towards the handle and twist until it snaps into place.