DYSON ONTRAC (01) PDF MANUAL

DYSON ONTRAC (01) PDF SUMMARY:

How do I adjust my headphones?

Put your headphones on and adjust the headband by sliding both sides until you have a comfortable fit.

How do I turn my headphones on and off?

Hold the power button for two seconds to turn the headphones on or off.

How do I pair my headphones?

Pairing your headphones is easiest with the MyDyson™ app. You can also connect using Bluetooth® wireless technology. Press and hold the Power button for five seconds until the LED flashes blue, indicating pairing mode. Then, open Bluetooth® in your mobile device’s settings menu, ensure Bluetooth® is turned on, and select ‘Audio On Trac’ to connect. Your MyDyson™ app will alert you when pairing is complete.

How do I control audio using the joystick?

• Play and pause: Press the middle of the joystick to play or pause.
• Skip and seek: Tap the joystick on the left or right to skip tracks. Press and hold to fast forward or rewind.
• Volume: Push the joystick up or down to adjust the volume.
• Activating voice assistant: Press and hold the middle of the joystick for two seconds to activate the voice control on your mobile device.
• Answering phone calls: To accept an incoming call, press the joystick. To decline a call, press and hold the joystick. To end a call, press the joystick.

How do I switch between Active Noise Cancellation (ANC) modes?

Double tap either ear cup to switch between noise-canceling modes.

What are the Active Noise Cancellation (ANC) modes?

• Isolation mode: Provides the maximum level of ANC, reducing surrounding background noise. This is the default setting.
• Transparency mode: Allows you to hear the environment around you.

How do I remove an outer cap?

To remove an outer cap, twist the outermost circular part counter-clockwise.

How do I install an outer cap?

Align the replacement outer cap on the headphones and twist clockwise until it clicks.

How do I remove an ear cushion?

To remove an ear cushion, twist it counter-clockwise.

How do I install an ear cushion?

Select the correct replacement for the left or right ear, marked with L and R on both the headset and the ear cushions themselves. Line up the long and short slots on the ear cushions with the matching ridges on the headset. Push down and twist clockwise until it clicks into place. Ensure the ear cushion is flush to the headphones to ensure proper functionality.

What is recommended after replacing the ear cushions?

After replacing the ear cushions, it’s recommended to recalibrate your headphones in the Product settings section of the MyDyson™ app, under Replacing accessories.

How do I clean the outer caps?

Wipe away dust or debris from the perforations in the ear cup covers with a soft, damp, lint-free cloth.

How do I clean the ear cushions and headband?

Wipe away dust or debris with a soft, damp, lint-free cloth.