AUTOMATIONDIRECT C-MORE EA9-T10CL (01) PDF DOCUMENT

After unpacking your AUTOMATIONDIRECT C-MORE EA9-T10CL, you should inspect all equipment for completeness. The package should contain the following items:

• Quick Start Guide

• Cutout Template*

• C-more Panel

• Gasket

• DC power connector

• Mounting Clips

• Logo Label*

*Some items may not be included with all models.

To provide DC power to the AUTOMATIONDIRECT C-MORE EA9-T10CL, follow these steps:

1. Wire a dedicated 12-24 VDC power source to the DC connector on the rear of the touch panel.

2. Wire the ground terminal to a proper equipment ground.

3. Turn on the power source and check the LED status indicators on the front and rear of the panel for proper indication.

NOTE: Use 60 / 75°C copper conductors only, 12 – 24 AWG.

For the AUTOMATIONDIRECT C-MORE EA9-T10CL, the following DC power specifications apply:

Recommended DC Supply Fuse:

DC-CON Tightening Torque:

To use an AC power source, you must install a C-more AC/DC Power Adapter (p/n EA-AC). Follow these steps:

1. Install the AC/DC Power Adapter to the rear of the touch panel.

2. Wire an AC voltage source of 100-240 VAC, 50/60 Hz, to its AC connector.

3. Turn on the power source and check the LED status indicators for proper indication.

The recommended AC supply fuse is a 3.0A time delay fuse.

The CPU Status LED (Green, Orange & Red) on the rear of the panel indicates the operational status of the CPU.

The Power LED on the front of the panel indicates the power status.

To mount the AUTOMATIONDIRECT C-MORE EA9-T10CL, you must prepare a cutout in your enclosure according to the specified dimensions. The panel should be mounted into an enclosure that utilizes a tool removable door/cover. The mounting brackets are located at 8 places on the rear of the panel.

Cutout Dimensions – inches [mm]:

Mounting Clip Specifications:

When installing the AUTOMATIONDIRECT C-MORE EA9-T10CL in an enclosure or cabinet, ensure a minimum clearance of:

• 4 inches from the top, bottom, and sides.

• 1.72 inches from the rear.

The AUTOMATIONDIRECT C-MORE EA9-T10CL may be mounted at any angle without derating consideration.

The UL Satisfaction Ratings for the AUTOMATIONDIRECT C-MORE EA9-T10CL are as follows:

• Input Ratings: 12-24 VDC, Class 2, SELV or LEC, Maximum 18.0W

• Terminal connecting wire size: 12-24 AWG

• Connecting torque: 71 – 85 oz-in (5-7 lbf-in) (0.5-0.6 Nm)

• Surrounding Air Temperature rating: 0 to 50°C (32 to 122°F)

• For use in Pollution Degree 2 environment.

• All interface ports are intended to be directly connected to an isolated secondary circuit.

• For use on a flat surface of a type 4X Indoor Use Only enclosure.

The display screen should be cleaned periodically by wiping it with a lint-free damp cloth using a mild soap solution. Use a dry or slightly dampened cloth to wipe any dirt from the labels on the back of the panel. Dry all surfaces with a lint-free cloth. Do not clean with ammonia-based products which are solvents as they will damage the face of the panel and the labels.

Yes, the touchscreen is designed to respond to a single touch. If the screen is touched at multiple points at the same time, an unexpected object may be activated.