MABE SIRIUS 360 RME1436 (01) PDF Document

To know your MABE SIRIUS 360 RME1436 is very simple and will allow you to obtain the best performance. It is important to read the instructions for installation, operation, and care of this product, since they contain valuable knowledge except when they have been supervised by an adult responsible for their safety. The product is not to be used by persons with reduced physical, sensory or mental capacities.

1. Remove all packaging materials: tape, cardboard, plastic bags.

2. Keep the unit upright.

3. Observe installation clearances. Leave at least 4 inches (10 cm) on top so that air may circulate, and 2 inches (5 cm) on sides and back.

4. Let the refrigerator stand for six to eight hours before connecting it.

5. Clean the refrigerator with a cloth and soapy water. Wait until dry before connecting it.

6. Connect the refrigerator. Before introducing food, allow it to work for two hours.

1. Carefully read the technical instructions for the appliance before turning it on for the first time.

2. The electrical installation must comply with local rules.

3. This product is not designed to be used by children.

4. Darken and cold doors generate gentle heating. This helps air to circulate.

5. Ensure that children are supervised so they do not play with the appliance.

6. Disconnect the refrigerator before performing cleaning or maintenance tasks.

7. To disconnect, grasp the plug and pull it out of the wall. Never pull from the cord.

8. Do not touch frozen surfaces with wet hands, since they may stick to the surface.

9. Never store fizzy liquids or sparkling beverages in the freezer.

10. Do not eat ice cubes straight out of the freezer. They may cause cold burns.

11. When putting something in the freezer, do not touch the bottom of the shelf since your hands might stick to it because it is so frozen.

12. If the mechanical refrigeration system has any damage, avoid exposing the product except as recommended by the manufacturer.

13. To freeze food in good condition, place it in the freezer compartment except for products whose packing indicates they must not be frozen.

14. To change the bulb:

– Disconnect the refrigerator.

– Remove the bulb cover. Hold the top half and pull towards yourself.

– Unscrew the bulb and replace it with a similar one.

– Hook the top section of the cover and hook the bottom. When putting the bulb cover on, the light is turned back on.

15. During periods of high ambient humidity, it is possible that light condensation may form on some external surfaces of the refrigerator such as the doors or sides. This is normal and is caused by the refrigerator’s refrigeration system. It will disappear when the ambient humidity decreases.

Do not connect other appliances to the same outlet.

Take the cord by the plug, not by the power cord.

The refrigerator has a polarized plug, and there is only one way to insert it. Do not remove the grounding terminal from the plug.

Due to the risk of injury, we strongly recommend that you do not use an extension cord. If it is absolutely necessary, then it must be a grounded three-wire extension cord. The plug and outlet must be able to support a 10 A (amperes) current and 127 V.

For more safety, the outlet should have a voltage regulator with at least 1000 watts.

To leave the refrigerator clean and maintain its quality it is necessary to clean it at least once a month. Before starting, disconnect it.

1. Never use abrasive cleaners, wire wool, scouring powder, or acid or alkaline substances.

2. Use a soft sponge or cloth soaked in a neutral cleaning solution (for example, baking soda dissolved in two liters of water is excellent).

3. Do not place electric parts close to water in order to avoid electric shock.

4. Use a special wax to clean the stainless steel (if applicable) every six months to wipe down the complete surface. To keep the steel shining, always wipe down the product horizontally.

5. Gaskets may be cleaned using a soft cloth and lukewarm soapy water. Dry carefully and completely.

6. The back of the refrigerator can accumulate dust. To achieve better energy efficiency, it is advisable to carefully clean the back of the appliance once a year with a soft brush or a vacuum cleaner.

Your refrigerator has insulating material and refrigerant substance (CYCLOPENTANE / R-600a) for which special treatment is required before being discarded. We recommend contacting your local agent regulations. If you have any doubt, contact the manufacturer of your product.

The insulation contains combustible blowing gases: the appliance should be disposed of in accordance with the applicable regulations. Avoid damage to the refrigeration circuit, especially the condenser.

When you dispose of your appliance, remove doors and leave shelves in such a way that children cannot get trapped inside.

The internal Cauline Control adjusts the refrigerator and freezer temperatures. Before making another adjustment to the thermostat, allow twenty-four hours to go by to check the temperature.

Recommended Temperatures:

Minimum Temp: Very few items stored.

Med Temp: Many items stored, door is frequently opened.

Maximum Temp: Many items stored, door is constantly opened.

When placing items in the refrigerator:

1. Leave a space between items to allow air to circulate.

2. Do not introduce hot foods. Wait until they are at room temperature, this will help to save energy.

3. Store foods with strong smells in containers with lids.

4. To preserve vegetables and fruit with high water content, wrap them in plastic bags with colors and flavors.

5. Some vegetables or fruits, e.g., marrows or tomatoes, can spoil if stored at very low temperatures. We recommend wrapping them in a bag and wash them before using them.

Fridge Temp: Use this option to control the temperature of the refrigerator. Activate it by pressing the button. To change the temperature, keep pushing until the desired level is reached. The level is shown by the lit LEDs. The “minimum temp” is the warmest and “maximum temp” is the coldest.

Lock: To block the external control and prevent accidental changes, press the lock button for three seconds. The LED will light up, indicating that the control is blocked. To unblock it, press the lock button for three seconds.

Holiday: Activate this function to save energy when you are away from home on holidays. This option will be activated with a simple push of the button and will change the refrigerator temperature to a minimum position.

The No Frost system ensures that it is not necessary to defrost the refrigerator manually. This automatic defrosting occurs during the compressor stops. The meltwater runs down a collector and evaporates in a pan on the compressor. This system ensures that ice and frost do not accumulate on the inner walls or on food. It also means that the cold air is more evenly distributed, which helps to preserve food.

A WARNING sticker is on the door. To maximize food life, do not block the air pick-up to the maximum fill line. Obstruction to the fan may reduce the proper cooling function of the product.

For first-time use, only use purified water. It is important to remember to change the water frequently to keep it fresh and to wash the container before filling it up.

1. Remove the cover as seen in the suggested movement.

2. Remove the tray carefully.

3. Fill on a flat surface to the level indicated and carefully place back in the freezer.

4. Once the ice is made, turn the handles and the ice will fall into the tank.

5. Remove the tank with the ice and serve.

Important: The water-fill-up-valve is factory set. This is a very important component and its position should not be changed. Do not attempt to dismantle the valve.

Note: The ice maker is an accessory that may not be included in all product models.

1. To remove: lift and pull it out.

2. To insert: place it on its place and push until you feel a stop in its back section. Push down firmly.

Important: If the ice maker is to be moved, we recommend following the factory instructions. Move the old only if it is necessary or when the product shows any damage. We recommend that the replacement is done by the Authorized Service Center.

This space is ideal for storing food for longer periods. To remove the drawer:

1. Pull the drawer until it hits the stop.

2. Lift the front part slightly and finish pulling it out.

3. To put it back in, repeat the steps in reverse order. For cleaning purposes, use water and soap to clean the drawer.

The ideal space for bottles and canned goods. To remove the shelf for cleaning purposes:

1. Hold it with both hands from the sides.

2. Push upwards until it is free.

3. To put it back in place, align the shelf on its tracks and push down until it is in place. You will hear a click to let you know it is secure. For cleaning purposes, use water and soap to clean the shelf. Do not use very hot water.