LELO SONA 2 CRUISE (01) PDF Document

Your LELO SONA 2 CRUISE has been locked for transportation. To unlock the device, simply connect the charger.

To operate the LELO SONA 2 CRUISE:

1. Press and hold the (()) button to turn it on.

2. Press the (()) button to switch between 12 modes.

3. Use the + and – buttons to increase or decrease the intensity.

4. Press and hold the (()) button to turn off.

Before first use, charge your LELO SONA 2 CRUISE for 2 hours. Only use original chargers provided by LELO.

1. Insert the DC plug into the DC port at the base of your LELO SONA 2 CRUISE.

2. Insert the mains plug into a USB Port.

3. The LED on the interface will pulse to indicate it is charging. When fully charged, the LED will emit a steady glow.

The LED on the interface of your LELO SONA 2 CRUISE indicates the following states:

Pulse: The device is charging.

Steady Glow: The device is fully charged.

Blinking White Light: The battery is running low.

Cruise Control is a fully automatic function, not a setting that requires you to turn it on or off. It is designed to detect any slowing motion of the motor and can boost the motor up again via PWM (Pulse Wave Modulation). This ensures that you enjoy consistent power and intensity, even while the LELO SONA 2 CRUISE is pressed firmly against your body.

You should use water-based lubricants, such as LELO Personal Moisturizer. Do not use hand creams or silicone-based lubricants with the LELO SONA 2 CRUISE, as they may make the silicone permanently tacky.

The LELO SONA 2 CRUISE is fully waterproof. Always clean the device thoroughly before and after each use.

1. Wash the silicone with warm water and antibacterial soap.

2. Rinse with clean hot water.

3. Pat dry with a lint-free cloth or towel.

Alternatively, rinse and spray with LELO Toy Cleaner, then rinse again and allow it to dry. Never use cleansers containing alcohol, petrol, or acetone.

If the LED does not pulse when charging:

The battery may be completely drained and will require several minutes to acknowledge that it is being charged.

The charger may not be properly connected. Check the wall and DC sockets.

If the device does not activate:

The battery may be empty. Recharge your LELO SONA 2 CRUISE.

The interface of your LELO SONA 2 CRUISE may be locked. To unlock it, hold down the + and – buttons simultaneously for 3 seconds.

Yes, the LELO SONA 2 CRUISE will initiate automatic shutdown every 20 minutes to assure the motor does not overheat if the product is misused.

Please adhere to the following safety guidelines:

Consult your healthcare provider with any questions or concerns regarding your condition.

This device should be used by people aged 18 years and over.

Minors should not clean and/or use the device unsupervised.

Only use the product for the intended purpose.

Do not share your sex toys with people other than your partner to avoid transmitting sexual diseases.

Do not use the product if you detect any cracks or signs of degradation on the covering material.

To prevent stains, do not keep your product on absorbent surfaces.

If your product operates abnormally, turn off and consult support.

Do not use the product if one or more components are damaged.

Avoid leaving the device in direct sunlight and NEVER expose it to extreme heat.