LELO SONA 2 (01) PDF Document

Your LELO SONA 2 may have been locked for transportation. To unlock it, simply connect the charger or press and hold the + and – buttons for 3 seconds.

• Charge your LELO SONA 2 for a maximum of 2 hours, or until the LED lights emit a steady glow.

• Unlock the device by pressing and holding the + and – buttons simultaneously for 3 seconds until the light turns on.

• Press the + button to turn the device on; press it again to increase the vibration strength.

• Press the () button to switch between the 12 vibration patterns.

• Press the – button to reduce the vibration strength.

• Press and hold the () button to turn the device off.

The LELO SONA 2 consists of the following parts:

• Pleasure Point

• +/- Intensity Controls

• Mode Selection Button

• Charging Port

Cruise Control is a fully automatic function available only on the LELO SONA 2 Cruise model. It is designed to detect any slowing motion of the motor, such as when the device is pressed firmly against your body, and can boost the motor up again via PWM (Pulse Wave Modulation). This feature ensures that you enjoy consistent power and intensity during use.

Begin by placing the mouth of the device on the clitoris, or next to the clitoris if the direct contact is too intense. Stimulate your clitoris as long as it doesn’t feel too sensitive. It is recommended to apply a liberal amount of LELO Personal Moisturizer to your body and the LELO SONA 2 before and during use.

Yes, you can bring your LELO SONA 2 into the bath or shower. However, please be mindful that water negates your body’s natural lubrication, which can render your clitoris more sensitive and dry. For the best experience, it is recommended to use the LELO SONA 2 with a water-based lubricant.

• Insert the DC plug into the DC port at the base of your LELO SONA 2.

• Insert the main plug into a USB port.

• Charge your device for a maximum of 2 hours, or until the LED lights emit a steady glow.

• When the battery is running low, the LED on your LELO SONA 2 will emit a blinking white light.

Only use the original chargers provided by LELO with your LELO SONA 2.

• Always clean your LELO SONA 2 thoroughly before and after each use. The device is fully waterproof, making cleaning simple.

• You can wash the silicone with warm water and antibacterial soap, rinse with clean hot water, and pat dry with a lint-free cloth or towel.

• Never use cleansers containing alcohol, petrol, or acetone.

• For extra care, gently wipe the inside of the pleasure point with a cotton swab.

• Avoid leaving your LELO SONA 2 in direct sunlight and NEVER expose it to extreme heat. Store it in a dust-free place and keep it away from products made of other materials.

Always use only water-based lubricants. Using the LELO SONA 2 with hand creams or silicone-based lubricants may make the silicone permanently tacky and ruin its texture irreversibly.

• The battery may be drained and will require several minutes to acknowledge that it is being charged.

• The charger may not be properly connected. Check the wall and DC sockets.

• The battery may be empty. Recharge your LELO SONA 2.

• The interface of your LELO SONA 2 might be locked. Hold down the + and – buttons for 5 seconds to unlock it.