LELO SILA CRUISE (01) PDF Document

Congratulations on acquiring your LELO SILA CRUISE. Before getting started, please follow these steps:

IMPORTANT: Your LELO SILA CRUISE has been locked for transportation. To unlock it, simply connect the charger or follow the unlocking instructions below.

1. Before its first use, charge your LELO SILA CRUISE for 2 hours.

2. To unlock the device, press and hold the + and – buttons simultaneously for 3 seconds until the light turns on.

3. For enhanced pleasure, apply LELO Personal Moisturizer to the product and your body.

To operate your LELO SILA CRUISE, use the following controls:

Turn On / Increase Intensity: Press the + button to turn the device on. Press the + button again to increase the vibration strength.

Switch Patterns: Press the () button to switch between the 8 different vibration patterns.

Reduce Intensity: Press the – button to reduce the vibration strength.

Turn Off: Press and hold the () button to turn the device off.

Cruise Control is a fully automatic function, not a setting that requires you to turn it on or off. It is designed to detect any slowing motion of the motor, for example when the LELO SILA CRUISE is pressed firmly against your body. The feature can then boost the motor up again via PWM (Pulse Wave Modulation). This ensures that you enjoy consistent power and intensity throughout use.

For the most pleasurable sensation, hold the LELO SILA CRUISE comfortably in your hand. You can place the clitoral stimulator on the clitoris, outer labia, or inner labia. For the best experience, apply a liberal amount of LELO Personal Moisturizer to your body and to the LELO SILA CRUISE before and during use.

To charge your LELO SILA CRUISE, follow these steps:

1. Insert the DC plug into the DC port at the base of your device.

2. Insert the mains plug into a USB Port.

The LED on the interface of your LELO SILA CRUISE will pulse to indicate it is charging. When it is fully charged, the LED will emit a steady glow. When the battery is running low, the LED on your LELO SILA CRUISE will emit a blinking white light. Only use original chargers provided by LELO with your LELO SILA CRUISE.

Cleaning:

Always clean your LELO SILA CRUISE thoroughly before and after each use. The device is fully waterproof, making cleaning simple. You can wash the silicone with warm water and antibacterial soap, rinse with clean hot water, and pat dry with a lint-free cloth or towel. Alternatively, you can rinse and spray with LELO Toy Cleaner, then rinse again and allow it to dry.

Important:

• Never use cleansers containing alcohol, petrol, or acetone.

• Using the LELO SILA CRUISE with hand creams or silicone-based lubricants may make the silicone permanently tacky.

Storage:

• Avoid leaving your LELO SILA CRUISE in direct sunlight and NEVER expose it to extreme heat.

• Store your LELO SILA CRUISE in a dust-free place and keep it away from products of other materials.

If the LED does not pulse when the charger is connected, try the following:

• The battery may be drained and will require several minutes to acknowledge that it is being charged. Wait a few minutes.

• The charger may not be properly connected. Check the wall and DC sockets to ensure a proper connection.

If your LELO SILA CRUISE does not turn on, it could be for one of these reasons:

• The battery is empty. Recharge your LELO SILA CRUISE.

• The interface of your LELO SILA CRUISE is locked. Hold down the + and – buttons for 5 seconds to unlock it.