LELO NEA 3 (01) PDF Document

The LELO NEA 3 is locked for transportation. To unlock the device, you can simply connect it to the charger or hold down both buttons simultaneously for 5 seconds.

This device should be used by persons aged 18 years and over. Persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge should use the device only if they have been given supervision or instruction concerning the use of the device in a safe way and understand the hazards involved.

Minors should not use the device and should not clean or use the device unsupervised.

Before the first use, charge your LELO NEA 3 for 2 hours. The operation of the interface is as follows:

To turn the device on: Press and hold the right button.

To switch between different modes: Perform a quick double press on the buttons.

To change the power level: Use a semi-long press on the left or the right button to adjust the power level up and down.

To turn the device off: Press and hold the left button.

To charge the device, insert the DC plug into the DC port at the base of the LELO NEA 3 and insert the mains plug into a USB Port. Only use original chargers provided by the manufacturer. The LED on the interface provides the following status updates:

Pulse: Indicates the device is currently charging.

Steady glow: Indicates the device is fully charged.

Blinking white light: Indicates the battery is running low.

The LELO NEA 3 is fully waterproof. Always clean the device thoroughly before and after each use using the following methods:

Method 1: Rinse and spray with a dedicated toy cleaner, then rinse again and allow it to dry.

Method 2: Wash the device with warm water and antibacterial soap, rinse with clean hot water, and pat dry with a lint-free cloth or towel.

Cleaning precautions: Never use cleansers containing alcohol, petrol, or acetone.

Storage: Avoid leaving the device in direct sunlight and never expose it to extreme heat. Store the LELO NEA 3 in a dust-free place and keep it away from products made of other materials.

If the LED does not pulse when the charger is connected:

The battery may be completely drained and will require several minutes to acknowledge that it is being charged.

Check the wall and DC sockets to ensure the charger is properly connected.

If the device does not activate when the right button is pressed:

The battery may be empty. Recharge the device.

The interface may be locked. Hold down the left and the right button for 5 seconds to unlock it.

For a more pleasurable sensation, you can apply a liberal amount of personal moisturizer to your body and the device before and during use. However, do not use the LELO NEA 3 with hand creams or silicone-based lubricants, as these may make the surface of the device permanently tacky.