LELO INSIGNIA (01) PDF Document

To lock your LELO INSIGNIA Pleasure Object between uses, hold down the + and – buttons for 5 seconds. The LED will flash once when it is locked. Repeat the process to unlock.

Note that charging automatically unlocks your Pleasure Object. Be sure that it is locked during transport to avoid accidental activation.

Pressing the + button activates your Pleasure Object. Hold this button to increase the vibration intensity and let go when you reach the level that you desire.

Holding the – button will decrease vibration intensity. Continue holding the – button to turn your Pleasure Object off.

When any of the buttons are pressed, the LED will light up, indicating that the interface is active.

When you first turn your LELO INSIGNIA Pleasure Object on, it is in continuous vibration mode. Press the centre button to move through the modes.

The LELO INSIGNIA range comes with 6 to 8 programmed stimulation modes that range from continuous to pulsing vibes and, in the case of SORAYA, alternating waves via the independent motors housed within.

Use the charging plug to push through the silicone that is covering the indentation at the base of your LELO INSIGNIA. When your device is done charging and you remove the adapter, the silicone reseals itself.

When the mains plug is inserted into the wall socket, the LED will pulse to indicate that your Pleasure Object is charging. When it is fully charged (after ca. 2 hours) the LED will emit a steady white glow.

Only use original chargers provided by LELO.

Do NOT charge while your LELO INSIGNIA is in water.

If the battery is running low, the LED indicator will prompt you to charge by flashing rapidly when the + button is pushed.

LELO recommends that you use a water-based lubricant with your Pleasure Object. Using a silicone-based lubricant could make the silicone permanently tacky. If you wish to use a silicone-based lubricant, perform a patch-test first.

Never use massage oil or hand cream as lubricants with your LELO INSIGNIA.

Always clean your LELO INSIGNIA thoroughly before and after each use. Wash the silicone with warm water and antibacterial soap, rinse with clean hot water and pat dry with a lint-free cloth or towel.

Never use cleansers containing alcohol, petrol or acetone.

Avoid leaving your LELO INSIGNIA in direct sunlight and NEVER expose it to extreme heat. Store your device in a dust-free place and keep it away from toys of other materials.

With or without the silicone skin, the product is still waterproof up to 1 metre.

If the LED does not pulse when connected:

The battery may be fully charged.

The battery may be drained and will require several minutes to acknowledge the charger.

The charger may not be properly connected. Check wall and DC sockets.

If the device does not activate:

The battery may be empty. Recharge your LELO INSIGNIA.

Your Pleasure Object is locked. Hold down the + and – buttons for 5 seconds to unlock it.