LELO LOKI WAVE 2 (01) PDF Document

Your LELO LOKI WAVE 2 has been locked for transportation. To unlock it, you can simply connect the charger. Alternatively, you can unlock the interface by holding down the + and – buttons simultaneously for 3 seconds.

The LELO LOKI WAVE 2 consists of the following parts:

• Insertable vibrator head (contact with skin)

• Vibrator finger (contact with skin)

• Ultra-smooth premium silicone body

• A / V – Mode selection buttons

• ON / OFF – Function button

• + / – Intensity control buttons

• Charging port

Before the first use, charge your LELO LOKI WAVE 2 for 2 hours.

1. Press the On/Off button to turn it on.

2. Press the Ʌ or V button to switch between the 12 available modes.

3. Use the + and the – buttons to increase or decrease the intensity.

4. Press and hold the On/Off button to turn it off.

Tip: For an even more pleasurable sensation, apply a liberal amount of LELO Personal Moisturizer to your body and to the LELO LOKI WAVE 2 before and during use.

To charge your LELO LOKI WAVE 2:

1. Insert the DC plug into the DC port at the base of your LELO LOKI WAVE 2.

2. Insert the mains plug into a USB Port.

The LED light on the interface indicates the battery status:

• A pulsing light indicates the device is charging.

• A steady glow means the device is fully charged.

• A blinking white light means the battery is running low.

Only use original chargers provided by LELO with your LOKI WAVE 2.

Always clean your LELO LOKI WAVE 2 thoroughly before and after each use. The device is fully waterproof, making cleaning simple.

1. Rinse and spray with LELO Toy Cleaner, then rinse again and allow it to dry.

2. Alternatively, you can wash the silicone with warm water and antibacterial soap, rinse with clean hot water, and pat dry with a lint-free cloth or towel.

Important Cleaning and Care Instructions:

• Never use cleansers containing alcohol, petrol, or acetone.

• Using hand creams or silicone-based lubricants may make the silicone permanently tacky.

• Avoid leaving your LELO LOKI WAVE 2 in direct sunlight, and NEVER expose it to extreme heat.

• Store your LELO LOKI WAVE 2 in a dust-free place and keep it away from products of other materials.

If the LED on your LELO LOKI WAVE 2 does not pulse when connected to the charger, check the following:

• The battery may be completely drained and will require several minutes to acknowledge that it is being charged.

• The charger may not be properly connected. Check the wall and DC sockets to ensure a secure connection.

If your LELO LOKI WAVE 2 does not activate when the On/Off button is pressed, it could be for one of two reasons:

• The battery is empty. Recharge your LELO LOKI WAVE 2.

• The interface of your LELO LOKI WAVE 2 is locked. Hold down the + and – buttons for 5 seconds to unlock it.

Materials: Body-safe silicone, ABS plastic

Finish: Smooth

Size: 196 x 91 x 42 mm / 7.7 x 3.6 x 1.7 in

Insertable length: 100 mm / 3.9 in

Weight: 196 g / 6.9 oz

Battery: Lithium 850 mAh 3.7 V

Charging: Up to 2 h at 5.0 V 750 mA

User time: Up to 1 h

Standby: Up to 90 days

Frequency: 122 Hz

Max. noise level: 60 dB

Interface: 5 buttons