LELO BILLY (01) PDF Document

Before charging, make sure the DC socket is free from water or lubricant residue.

1. Gently remove the protective silicone cap on the back of your LELO BILLY.

2. Gently insert the DC plug into the DC socket, deep enough to feel a subtle click.

3. Insert the mains plug into the wall socket. The LED will pulse to indicate that LELO BILLY is charging. When it is fully charged (after c. 2 hours) the LED will emit a steady glow.

Only use original chargers provided by LELO.

If the battery is running low, the LED indicator will prompt you to charge by emitting a red glow.

Hold down the + quadrant on the interface dial to activate your LELO BILLY. Continue pressing it to increase vibration until you reach the vibration intensity you require.

Press the – quadrant on the interface dial to decrease vibration intensity.

To turn off your LELO BILLY, hold down the – quadrant. Vibration intensity will decrease until it is completely off.

When transporting your LELO BILLY, always lock the interface dial to prevent accidental activation.

To lock, hold down the complete interface dial for five seconds. The LED will light up and then go dark to indicate LELO BILLY is locked.

To unlock, repeat the process until the LED lights up.

Note that charging will automatically unlock LELO BILLY.

Before inserting LELO BILLY, use a lubricant (ideally water-based) to lubricate your anus. You may wish to use a finger to help relax your sphincter muscles before insertion as well. Many people find it easier to relax their muscles when lying on their side with knees pulled up to the stomach; this is a stable position that lets you make yourself comfortable while exploring your best use of LELO BILLY.

Insert LELO BILLY carefully, making sure it curves up towards your stomach. Never force it, and never insert any part of the ring. Always stop immediately if you feel pain.

Your LELO BILLY has five programmed stimulation modes. When you first turn LELO BILLY on, it is in continuous vibration mode. Press the Up or Down arrow quadrants of the interface dial to move through the modes.

LELO recommends that you NOT use a silicone-based lubricant with LELO BILLY, as this could make the silicone permanently tacky. A water-based lubricant is the safest option. If you wish to use a silicone-based lubricant, perform a patch-test first.

Always clean LELO BILLY thoroughly before and after each use. Wash the stem with warm water and antibacterial soap, rinse with clean hot water and pat dry with a lint-free cloth or towel.

Avoid submerging and getting water into the DC socket or around the interface dial. Never use cleansers containing alcohol, petrol or acetone.

Avoid leaving your LELO BILLY in direct sunlight and NEVER expose him to extreme heat.

Store your LELO BILLY in a dust-free place and keep him away from toys of other materials.

The battery may be fully charged.

The battery may be drained and will require several minutes to acknowledge the charger.

The charger may not be properly connected. Check wall and DC sockets.

The battery may be empty. Recharge your LELO BILLY.

The interface dial may be locked. Unlock by holding down the whole interface dial for 5 seconds.

The crossed-out dustbin symbol indicates that this pleasure object should not be treated as household waste, but rather be brought to the appropriate collection point for recycling of electrical and electronic equipment.