BABYLISS E795E (01) PDF Document

The recommended cutting guides for the BABYLISS E795E are:

• Hair cutting guide: 3 to 24 mm
• Beard cutting guide: 0.5 to 4.5 mm

The accessories included with the BABYLISS E795E are:

• Adapter for electrical connection (5)
• Cleaning brush (6)
• Lubricating oil (7)
• Storage/cleaning pouch (8)

The electrical characteristics of the BABYLISS E795E are:

• Charging voltage: 3V
• Charging current: 300 mA
• Battery type: 2 x AAA Ni-MH 600 mAh

Connect the BABYLISS E795E to the mains supply by plugging the adapter (5) into the unit’s base and then into the wall socket. Use only the adapter supplied with the clipper.

To preserve the life of the rechargeable batteries of the BABYLISS E795E, you should fully discharge them every 3 months, or 3 times a year. Then, recharge the BABYLISS E795E for a minimum of 12 hours. The initial charge should also be 12 hours.

To perform a full charge on the BABYLISS E795E, the charge time is 12 hours.

A 45-minute charge on the BABYLISS E795E provides enough power for approximately 1 use.

The maximum use time when operating the BABYLISS E795E on the mains is not limited.

To turn the BABYLISS E795E ON, slide the ON/OFF switch (1) to the ‘I’ position. To turn the BABYLISS E795E OFF, slide the ON/OFF switch (1) to the ‘O’ position.

The BABYLISS E795E comes with 2 precision cutting guides for guaranteed even cutting. Consult the table provided for selecting the length of cut.

To attach the cutting guide, position the guide over the blades. The notches on the guide must fit onto the notches on the BABYLISS E795E. To remove the cutting guide, detach it from the blades.

The precision wheel (3) on the BABYLISS E795E allows you to adjust the cut length to the desired setting. The setting number is indicated in the window (4) located on the main body of the unit. The length of cut is displayed in millimeters (mm) and is set by turning the precision wheel (3) until the desired length appears in the window (4). The setting is locked for maximum precision.

The BABYLISS E795E blades are removable for easier cleaning. To remove the blades, hold the unit and gently push the blades upward with your thumb. To replace the blades, position the attachment to the top of the BABYLISS E795E and push until you hear a click. Use the cleaning brush (6) to remove the hair. The blades are lubricated at the factory, and for optimal performance, they should be regularly lubricated. Use the lubricating oil (7) supplied with the BABYLISS E795E and apply a few drops to the blades after each use. Remove the excess oil with a soft, dry cloth. The first lubrication before using the clipper is mandatory, or a few drops of lubricating oil (7) on the blades before the first use is required.

Ensure the BABYLISS E795E is turned off and unplugged before cleaning. The blades are removable and can be cleaned using the supplied brush (6). To clean the unit, wipe with a damp cloth and dry immediately. Do not immerse the BABYLISS E795E in water or other liquids. Ensure the blades are completely dry before reattaching them to the clipper body. Do not use abrasive or corrosive cleaning products.