BABYLISS AIR POWER PRO D6555DU (01) PDF Document

For UK Only: This appliance must not be used in the bathroom.

Outside the UK: If using the appliance in a bathroom, unplug after use as the proximity of water can be dangerous even if the appliance is switched off. For additional protection, the installation of a residual current device (RCD) with a rated residual operating current not exceeding 30mA is advisable in the electrical circuit supplying the bathroom. Ask your installer for advice.

WARNING! Do not use this appliance near bathtubs, showers, basins, or other vessels containing water.

This appliance is equipped with a safety thermostat. In the event of overheating, the appliance will either stop automatically or run hot and cold intermittently.

Should this happen, switch the appliance to the ‘0’ position, unplug and allow to cool for 10 minutes.

Before use, ensure the rear filter is clear of hair and other debris.

Plug in and switch on. If the appliance continues to overheat discontinue use immediately, switch off and unplug, and contact the Customer Care Line.

ALWAYS keep out of reach of children (during and after use and whilst cooling).

Always take extra care if used on children or near children.

Do not use on very young children.

Do not immerse the appliance into water or other liquids.

Never look directly into the barrel of the hairdryer when it is switched on.

Do not use if damaged, or if the appliance has been dropped.

Do not leave the appliance unattended when switched on or plugged in.

Take care that the air vents do not become blocked when in use. Ensure the rear filter is clear of hair and other debris before use.

During use, do not place the appliance on any heat sensitive surface.

Take care to avoid the hot surface of the appliance coming into direct contact with the skin, in particular the ears, eyes, face, and neck.

Allow the appliance to cool before storing away.

There are 4 heat / 3 speed settings plus the cool shot button.

The temperatures are indicated by the light around the heat button: blue for cool, yellow for low, orange for medium, and red for high temperature.

The speed indicator light is white.

Use the higher heat and higher speed settings for initial drying.

Use the lower heat and lower speed settings for styling and scrunch drying as the hair begins to dry.

To operate the cool shot, hold down the button continuously. Use the cool shot to rapidly cool the hair and set the style.

1. Towel dry and detangle hair.

2. Plug the appliance into a suitable mains socket.

3. Select the required heat and speed settings.

4. IMPORTANT! Always keep the rear of the appliance away from the hair during use, to prevent it being drawn in through the rear air filter.

5. After use, switch off and unplug the appliance.

6. Allow the appliance to cool before storing away.

The appliance comes with 4 x 70mm and 6 x 60mm concentrator nozzles with a secure fit lock-in system to give a faster streamlined airflow for styling and smoothing of curly hair, shorter lengths, and fringes.

To install: Align the 4 points on the base of the accessory with the 4 holes on the nozzle of the dryer. Twist the accessory onto the dryer to complete installation.

IMPORTANT! Only use the concentrator nozzles on the lowest heat / speed setting.

The large curl diffuser features a secure fit lock-in system and gives fast, frizz-free drying creating soft, defined waves, curls, and coils.

To install: Align the 4 points on the base of the accessory with the 4 holes on the nozzle of the dryer. Twist the accessory onto the dryer to complete installation.

IMPORTANT! Only use the diffuser on the lowest heat / speed setting.

Yes, the appliance features a Memory Function. Smart detection automatically memorizes the last settings used. The last mode used remains in the memory until the next use.

Ensure the appliance is switched off, unplugged, and cool.

To clean the outside of the appliance, wipe with a damp cloth. Make sure that no water enters the appliance and it is completely dry before use.

Do not wrap the lead around the appliance, instead coil the lead loosely by the side of the appliance.

Do not use the appliance at a stretch from the power point.

Always unplug after use.

The magnetic rear filter is self-aligning and can be easily removed and cleaned. It features Electronic Detection where power automatically shuts off when the filter is removed.

To clean the filter:

1. Ensure the appliance is switched off, unplugged, and cool.

2. Holding the handle of the dryer, pull the magnetic rear filter to remove.

3. Dust off lightly to remove any hair or debris that has built up on the filter mesh.

4. Replace the rear filter.

Note: When the rear filter is removed the temperature switch light will flash red. To turn the dryer back on, re-fit the rear filter and power back on the dryer.

After use, do not coil the lead around the appliance as this may cause damage to the lead. Instead, coil the lead loosely by the side of the appliance.

Do not use the appliance if the lead is damaged. In the event of damage, discontinue use immediately. No repair must be attempted by the consumer.

The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead, it should be handed to an appropriate collection point for the recycling of Electrical and Electronic equipment.

By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.