BABYLISS BLACK ONYX ST484U (01) PDF Document

The guide for the temperature settings for the BABYLISS BLACK ONYX ST484U is:

If you have delicate, fine or coloured hair, use the lower heat settings. For thicker hair, use the higher heat settings. It is suggested to always complete a test on initial use to ensure the correct temperature is used on the hair type. Start on the lowest setting and increase the temperature until the desired result is achieved.

To switch on the BABYLISS BLACK ONYX ST484U for straightening:

1. Plug in the appliance and press the button marked ‘⏻’ to switch on.

2. To select a heat setting suitable for your hair type, press the ‘+’ and ‘-‘ buttons.

3. The indicator light will blink until the heat setting selected has been reached.

4. Once the temperature has been reached, the indicator will remain solid in colour.

Instructions for straightening with the BABYLISS BLACK ONYX ST484U:

1. Ensure hair is dry and combed through.

2. Divide the hair into sections.

3. Plug in the appliance and press the button marked ‘⏻’ to switch on.

4. To select a heat setting suitable for your hair type, press the ‘+’ and ‘-‘ buttons. The indicator light will blink until the heat setting selected has been reached. Once the temperature has been reached, the indicator will remain solid in colour.

5. Take a section of hair and place it between the styling plates.

6. Starting at the root, close the plates applying gentle pressure and glide down the section in one smooth movement.

7. If you wish to create shape at the ends of the hair, slightly bend your wrist inwards as you reach the end of each section.

8. Repeat as necessary through the remaining sections of hair.

9. Allow the hair to cool fully before combing through.

Instructions for creating curls with the BABYLISS BLACK ONYX ST484U:

1. Ensure the cool tips are in position at the end of the appliance.

2. Plug in the appliance and press the button marked ‘⏻’ to switch on.

3. To select a temperature setting suitable for your hair type, press the ‘+’ and ‘-‘ buttons. The indicator light will blink until the heat setting selected has been reached. Once the temperature has been reached, the indicator will remain solid in colour.

4. Separate a section of hair. The smaller the section, the more defined the curl. The larger the section, the looser the curl.

5. Take the hair section and place it between the plates, roughly 3 inches from the roots.

6. Holding the appliance handle in one hand and the cool tips in the other, turn the appliance 180° back on itself so that the hair is wrapped once around the outside of the appliance.

7. Slowly glide the appliance along the length of hair from root to tip in a downward motion.

8. Release the appliance from the hair.

9. To ensure the curl sits neatly in place, hold the end of the section you have curled and twist it in the direction of the curl.

Yes, the BABYLISS BLACK ONYX ST484U has an automatic shut off feature for added safety. If the appliance is switched on for more than 72 minutes continuously, then it will automatically switch off. If you wish to continue using the appliance after this time, simply press the button ‘⏻’ to turn the power on.

Turning on the BABYLISS BLACK ONYX ST484U will automatically activate the ionic technology. The release of the ions from the ports produces a slight buzzing noise.

The BABYLISS BLACK ONYX ST484U comes with a heat wrap for use during and after styling. During use, do not place the appliance on any heat sensitive surface, even when using the heat wrap provided. After use, switch off and unplug the appliance. Immediately wrap the appliance in the heat wrap provided and allow it to fully cool down. Continue to keep it out of reach of children as it will remain hot for several minutes.

The following are important safety warnings regarding water and the BABYLISS BLACK ONYX ST484U:

• WARNING! Do not use this appliance near bathtubs, showers, basins or other vessels containing water.

• Do not immerse the appliance into water or other liquids.

• UK Only: This appliance must not be used in the bathroom.

• Outside the UK: If using the appliance in a bathroom, unplug after use as the proximity of water can be dangerous even if the appliance is switched off. For additional protection the installation of a residual current device (RCD) with a rated residual operating current not exceeding 30mA is advisable in the electrical circuit supplying the bathroom. Ask your installer for advice.

Regarding the power lead for the BABYLISS BLACK ONYX ST484U:

• Do not coil the lead around the appliance after use as this may cause damage. Instead, coil loosely by the side of the appliance.

• Do not wrap the lead around the appliance, instead coil the lead loosely by the side of the appliance.

• Do not use the appliance at a stretch from the power point.

General safety cautions for the BABYLISS BLACK ONYX ST484U:

• WARNING! BURN HAZARD: THIS APPLIANCE GETS HOT! ALWAYS keep out of reach of children (during and after use and whilst cooling).

• Always take extra care if used on children or near children.

• Do not use on very young children.

• Always inspect the appliance before use for noticeable signs of damage. Do not use if damaged, or if the appliance has been dropped. In the event of damage, discontinue use immediately.

• Do not use the appliance if the lead is damaged.

• Do not leave the appliance unattended when switched on or plugged in.

• During use, do not place the appliance on any heat sensitive surface, even when using the heat wrap provided.

• WARNING! Only hold the handle during use. Do not touch the hot surfaces of the appliance when in use as these can be extremely hot.

• Take care to avoid the hot surface of the appliance coming into direct contact with the skin, in particular the eyes, ears, face and neck.

• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand, the hazards involved. Children shall not play with the appliance. Cleaning and use maintenance shall not be made by children without supervision.

• Allow the appliance to cool before storing away.

• Do not use any accessories other than those recommended by BaByliss.

• Always unplug the appliance when not in use or before cleaning.

• Always unplug after use.