TOHNICHI NTD (01) PDF DOCUMENT

In order to use the TOHNICHI NTD torque driver properly and safely, please read the operating instructions before operation. Keep these operating instructions for future use.

The TOHNICHI NTD torque driver is used for mass production and maintenance services, and is suitable for single purpose tightening.

The TOHNICHI NTD features a toggle type torque detection mechanism that ensures accuracy and long durability. When you feel a click, tightening is completed.

Make sure there is no oil or grease on the grip. A slip of the hand while tightening may cause an accident or injury.

Do not set the torque driver beyond the maximum torque setting. This will cause damage or injury.

Check for cracks, scratches, and rust. These will cause damage to the driver and may result in an injury. If such conditions exist, have a functional test performed and repair if necessary.

Do not drop the torque driver or apply a strong shock or jolt. This will cause damage or deformation as well as decrease the accuracy and durability, which may cause an accident or injury.

Do not use the torque driver in the rain, high temperature, or high humidity, as this may result in malfunction due to rust.

Do not use the torque driver where there are high levels of dirt or dust.

1. Torque Setting: Hold the grip of the Driver in your hand, insert the Adjusting Bar into the slit of the Adjusting Screw and turn the Adjusting Bar. When turning the Adjusting Screw clockwise, the torque will increase. Use a TDT3-G torque driver tester to set the desired torque. (The Adjusting Bar is an optional accessory.)

2. Insert Bit: Insert the bit into the adapter of the Driver.

3. Engage Screw: Insert the tip of the bit into the slit of the screw head.

4. Tighten: Turn the Torque Driver clockwise to tighten.

5. Completion: Tightening is completed when a click is felt.

Note on RNTD Model: The RNTD model is a rotary slip clutch type.

Note on NTD Model: When reaching the set torque, the break is felt by hand in 15 degrees. Stop and complete the tightening work within the 15 degrees.

Applying more torque beyond the click with the NTD model will lead to over-torquing.

Since the RNTD model is a rotary slip clutch type mechanism, over-torquing is eliminated. However, idle extra clicks will result in clutch engagement wearing and may shorten durability.

Select a proper bit to adapt to the slit of the screw head. If the size of the bit is not correct, the screw head may be damaged by the bit.

When inserting the bit, push the bit until the ball in the Coupler stays in the center of the bit groove.

If the bit is tight when removing, use pliers to pull it out.

1. Perform regular inspection for function and accuracy.

2. Stop operation immediately if there is any sign of abnormality. Refer all servicing to your Tohnichi dealer.

3. Since professional repair is required, do not attempt to repair the Torque Driver yourself.

4. When storing the Torque Driver for a long time, keep it in a dry place.

Accuracy for all models is ±3%. Loading direction is clockwise.

Notes:

For RNTD120CN, 260CN, a black-colored resin grip is supplied as a standard accessory.

For NTD120CN, 260CN, a green-colored resin grip is supplied as a standard accessory.

A T-bar is a standard accessory for NTD 500CN and 1000CN only.

Note: The numbers in the table are treated as 3 significant figures.

1N·m = 10.1972kgf·cm ≈ 10.2kgf·cm

1kgf·cm = 0.0980665N·m ≈ 0.098N·m

Application: Calibration for Torque Driver.

Features:

Loading device eliminates measurement errors.

Operator can visibly check the judgment result with a white/red/blue display by judgment function.

Specifications: