SONY BRAVIA KD-55X80K (03) PDF Document

To open the help guide, press the Input button on the remote control and select Help. If Help does not exist, select Edit and add Help.

It takes time to initialize the system. Wait for about one minute and then operate it again.

Warning: The reset will clear all of your customized settings including the parental lock setting.

You can reset the SONY BRAVIA KD-55X80K to factory settings by selecting Factory data reset in the settings menu.

To force a factory data reset, unplug the AC power cord. Press and hold the Power button on the SONY BRAVIA KD-55X80K, then plug in the AC power cord.

Replace the batteries. Also, ensure you are pointing the remote control directly at the IR sensor located on the SONY BRAVIA KD-55X80K and that no objects are blocking the path. Additionally, check that fluorescent lamps are not interfering with the remote control signal.

Enter 4357 for the PIN and then enter the new PIN.

1. Restart your SONY BRAVIA KD-55X80K by pressing the power button on the remote control for about five seconds. The TV will restart.

2. If the TV does not recover, try unplugging the AC power cord, then press the power button on the TV and release it. Wait for two minutes, and plug in the AC power cord.

3. Alternatively, press the power button on the TV for about 40 seconds until the TV turns off.

4. Refer to the on-screen Help menu.

5. Connect your SONY BRAVIA KD-55X80K to the Internet and perform a software update.

6. Perform a factory data reset.

The wall-mount hole pattern for the SONY BRAVIA KD-55X80K is 300 × 300 mm.

You should secure the SONY BRAVIA KD-55X80K to a wall and/or a stand.

When securing to a stand:

1. Secure the stand for the SONY BRAVIA KD-55X80K. Use two angle braces to secure the stand. Attach one side of the angle brace to the wall stud and the other side to the stand.

2. Secure the SONY BRAVIA KD-55X80K to the stand using M6 machine screws (screwed into the rear cover), a screw or similar attached to the stand, and a rope or chain strong enough to support the weight of the TV. Ensure there is no excess slack in the rope or chain.

When securing to a wall:

1. Use bolts, a wall anchor, and a chain or rope.

2. Remove the upper two screws from the rear of the SONY BRAVIA KD-55X80K before anchoring to a wall.

Disconnect all cables when carrying the SONY BRAVIA KD-55X80K. Two or more persons are needed to transport the TV. Correct hand placement while carrying the TV is very important for safety and to avoid damage.

For best picture quality, do not expose the screen to direct illumination or sunlight. Avoid installing the SONY BRAVIA KD-55X80K in a room with reflective wall and floor materials.

To enable the built-in MIC, press the Google Assistant button on the remote control and follow the on-screen instructions.

The supported video formats include:

4096 × 2160p (60 Hz), 4096 × 2160p (24 Hz), 3840 × 2160p (60 Hz), 3840 × 2160p (24, 30 Hz), 1080p (30, 60 Hz), 1080/24p, 1080i (60 Hz), 720p (30, 60 Hz), 720/24p, 480p, and PC Formats.