SONY BRAVIA KDL-46HX820 (01) PDF Document

To insert the batteries, follow these steps:

Step 1. Remove the protection sheet.

Step 2. Push and slide the cover upward.

Step 3. Insert the two size AAA batteries correctly.

When setting up your SONY BRAVIA KDL-46HX820, please consider the following:

Disconnect all cables when carrying the TV. Carry the TV with an adequate number of people, as larger size TVs require two or more people. Ensure your TV has adequate ventilation. Do not expose the screen to direct illumination or sunlight for best picture quality. Avoid installing the TV in a room with reflective wall and floor materials. Do not move the TV from a cold area to a warm area, as sudden temperature changes may cause moisture condensation, which can lead to poor picture or color. Ensure there are no objects in front of the TV and do not expose the Intelligent Presence Sensor to direct sunlight or strong light.

To perform the initial setup, follow these steps:

Step 1. Complete all cable connections before proceeding and connect the TV to a power outlet.

Step 2. Check that the ENERGY SAVING switch is set to on.

Step 3. Press the power button on the TV. The power indicator will light green, and the Language menu will appear on the screen.

Step 4. Follow the instructions provided on the screen.

Step 5. Select Continue to scan for available channels and enable the Rovi On Screen Guide feature.

Follow these cleaning guidelines to safely care for your SONY BRAVIA KDL-46HX820:

Unplug the TV and other connected equipment from the wall outlet before cleaning. Wipe the LCD screen gently with a soft cloth. You may remove stubborn stains with a cloth slightly moistened with a solution of mild soap and warm water. If using a chemically pretreated cloth, follow the instructions on the package. Never spray water or detergent directly on the TV set, as it may drip and cause damage. Do not use strong solvents like thinner, alcohol, or benzine. Do not plug the TV back in until all moisture from cleaning has completely evaporated.

If the standby indicator is flashing, count the number of times it flashes, noting that the interval time is three seconds. Press the power button on the TV to turn it off, disconnect the AC power cord, and provide the flash count information to support for assistance.

You can access the built-in operating instructions by pressing the i-MANUAL button on the remote control. Use the arrow buttons to navigate and select items.

To program the remote control for other equipment, follow these steps:

Step 1. Find the code in the manufacturer code list that corresponds to your equipment.

Step 2. Press and hold the desired function button (DVD, AMP, or STB) simultaneously with the TV power button, then release. The function button will blink for about 30 seconds.

Step 3. Enter the five-digit code using the number buttons while the function button is lit.

Step 4. Press the button in the center of the arrow keys to confirm the code. If programmed successfully, the function button will blink twice; otherwise, it will blink five times.

Follow these steps to set up a wired network:

Step 1. Press the HOME button on the remote, then select Network, followed by Network Setup.

Step 2. Select Wired Setup.

Step 3. Select Auto to set the IP address and proxy server automatically, or select Custom to set them manually.

Step 4. Follow the instructions on the setup screen.