Free English JOHN DEERE SEEDSTAR 3 AIRCART (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD JOHN DEERE SEEDSTAR 3 AIRCART (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
What do the different colors for the JOHN DEERE SEEDSTAR 3 AIRCART meter control indicate?
The colors for the meter control on the JOHN DEERE SEEDSTAR 3 AIRCART indicate specific settings:
Yellow: Low Rates and granular products.
Black: Regular rates.
Green: High volume rates.
Blue: Very high rates.
Orange: Large seeds.
What do the different colors for the JOHN DEERE SEEDSTAR 3 AIRCART SectionCommand status mean?
The SectionCommand status colors on the JOHN DEERE SEEDSTAR 3 AIRCART indicate the following:
Green: Open.
Black: Closed by SectionControl.
White: Closed manually by SectionCommand.
Red: SectionCommand and gate status do not match.
How do I adjust variable rates on the JOHN DEERE SEEDSTAR 3 AIRCART?
Use the variable rate selection feature to choose a programmed rate. You can use the plus and minus buttons to adjust variable rates for each individual meter on the JOHN DEERE SEEDSTAR 3 AIRCART.
How can I perform the meter calibration procedure on the JOHN DEERE SEEDSTAR 3 AIRCART?
To calibrate a meter on the JOHN DEERE SEEDSTAR 3 AIRCART, navigate to the ActiveCal screen, select the tank you wish to calibrate, and press the button to start the calibration process.
How do I configure the rows per primary on the JOHN DEERE SEEDSTAR 3 AIRCART?
In the cart and tool setup menu, you can press the button to configure rows per primary if needed. The rows are pre populated, and you can adjust the shoot selection (Top or Bottom) for the selected tank filling (Mini, Front, Middle, Rear). Press the continue button to accept modified values or the cancel button to restore previous settings.
What does the John Deere SEEDSTAR 3 AIRCART cart and tool setup allow me to configure?
The cart and tool setup on the JOHN DEERE SEEDSTAR 3 AIRCART allows you to manage the following:
Cart size in bushels.
The type of tool remote switch (Height Sensor, CAN Height Sensor, or None).
Enable or disable Section Command.
Enable or disable Independent Cart Braking.
Enable or disable Dual Blower.
Select the tool model.
Enable or disable Double Shoot.
Select nominal tool width.
Select row spacing.
How do I set up meters for the JOHN DEERE SEEDSTAR 3 AIRCART?
In the meter setup screen for the JOHN DEERE SEEDSTAR 3 AIRCART, you can:
Select the tank.
Select the product and product type.
Select the roller.
Set variable rate increments.
Manually enter the meter displacement value.
How do I manage section control for the JOHN DEERE SEEDSTAR 3 AIRCART?
On the SectionCommand run screen of the JOHN DEERE SEEDSTAR 3 AIRCART, you can:
Enable or disable sections individually.
Use the enable all button to enable all sections.
Press the button to input section on/off times.
CLICK HERE TO DOWNLOAD JOHN DEERE SEEDSTAR 3 AIRCART (01) PDF DOCUMENT