Free English JOHN DEERE SEEDSTAR 1990 CCS (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD JOHN DEERE SEEDSTAR 1990 CCS (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
How do I interpret the drives status bar colors on the JOHN DEERE SEEDSTAR 1990 CCS?
The green bar indicates that the clutch is engaged and the drives are active. A gray bar indicates that the clutch is disengaged and the drives are inactive.
What do the population at a glance colors represent on the JOHN DEERE SEEDSTAR 1990 CCS?
Black bars indicate that the row is seeding normally. Orange bars indicate that the row is seeding above or below the alarm setpoints. Red bars indicate that the row is not seeding.
How do I interpret the sensor status colors on the JOHN DEERE SEEDSTAR 1990 CCS?
White indicates the drive is inactive and the sensor is on. Black indicates that SwathControl has deactivated the sensors. Green indicates that product flow is detected. Red indicates that the hose is blocked.
How do I switch between display modes on the JOHN DEERE SEEDSTAR 1990 CCS?
Select the Toggle button to switch between Scan mode and Population At A Glance mode.
How do I toggle the average seeds per area display on the JOHN DEERE SEEDSTAR 1990 CCS?
Select the average seeds per area button to toggle between the entire machine average and the drive section average.
How do I configure the counting settings for the JOHN DEERE SEEDSTAR 1990 CCS?
Select Menu, then the Blockage and Counting button, followed by the Counting Configuration softkey and the Setup tab. Select or deselect the Single Rank check box to match your machine design. If the machine has two ranks, select the Row Width drop down menu and choose the current width. For both ranks seeding, select narrow spacing; for single rank seeding, select wide spacing.
How do I set the target population and alert limits on the JOHN DEERE SEEDSTAR 1990 CCS?
Select the Population tab. Select the Target Population input box and enter the intended seeding rate. Select the Alert Limit input boxes and enter the actual values or the percentage of the target.
How do I perform a population adjustment on the JOHN DEERE SEEDSTAR 1990 CCS?
Select the Population Adjust drop down menu. Perform a field rate check. Divide the actual population by the displayed population, multiply the result by 100, and enter the resulting value for the population adjustment.
How do I change the speed source on the JOHN DEERE SEEDSTAR 1990 CCS?
Select Menu, then the Blockage and Counting button, then the Counting Configuration softkey, and finally the Population tab. Select the Speed Source drop down at the bottom of the screen.
How do I set up blockage monitoring on the JOHN DEERE SEEDSTAR 1990 CCS?
Select Menu, then the Blockage and Counting button, followed by the Blockage Configuration softkey and the Run Setup tab. Access the Row Fail Rate drop down menu to select the level of sensor response. Once the seed rate is verified in the field, set the level as sensitive as possible without triggering nuisance alerts. For Sorghum and Milo, the setting must be 1 seed every 3 seconds.
How do I select the monitor pattern for the JOHN DEERE SEEDSTAR 1990 CCS?
Select the Blockage Pattern drop down menu. If the far left active row is on the front rank, select Even Rows On. If the far left active row is on the rear rank, select Odd Rows On.
CLICK HERE TO DOWNLOAD JOHN DEERE SEEDSTAR 1990 CCS (01) PDF DOCUMENT