INSE S190 (01) PDF Document

When using an electrical appliance, basic precautions should always be followed, including the following:

• Do not use near open flames.

• Do not store near heat sources.

• Do not pick up water or liquids.

• Do not pick up burning objects.

• Do not put hands near the brush bar when the machine is in use.

• Do not place on or near the cooker.

• Do not use to pick up water or any other liquid, as this may cause electric shock.

• Do not use to pick up sharp objects such as glass or screws, etc.

• Do not use the appliance to pick up flammable liquid, matches, cigarette ends, hot ashes or any hot, burning or smoking objects.

• Do not use if any of its openings are blocked.

• Do not store the appliance in direct sunlight or in high humidity conditions.

• Do not use this appliance outdoors.

• Do not use any damaged accessories or adaptors.

• Do not use any parts/accessories or adaptors other than those supplied with this appliance, as this may cause damage.

• Do not use the appliance for anything other than its intended use.

• Do not use the appliance if it has been dropped or if there are visible signs of damage.

• Do not use the adaptor to recharge non-rechargeable batteries.

• Do not remove the adaptor from the mains power supply by pulling the cord; switch off and remove the plug by hand.

• Do not expose the appliance to rain.

• Do not operate the appliance with wet hands.

• Do not immerse the appliance in water or any other liquid.

• Only use with the provided power adapter.

• Use of an extension power cord is not allowed.

• Always ensure that the appliance has cooled fully after use before performing any cleaning or user maintenance.

• Switch off the appliance and disconnect it from the mains power supply before changing or fitting accessories.

• Take care when equipping accessories with rotating parts as this could cause entrapment.

• This appliance is intended for domestic use only. It should not be used for commercial purposes.

• Keep the appliance away from other heat emitting appliances.

• Keep the appliance away from heat or sharp edges that could cause damage.

• Keep away from children aged below 8.

• This appliance is not a toy. Children should be supervised to ensure that they do not play with the appliance.

• Check the voltage indicated on the rating plate and confirm you connect the appliance to the power supply with correct voltage.

Read all safety warnings and instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury.

1. Prevent unintentional starting ensure the switch is in the off-position before connecting pack, picking up, or carrying the appliance. Carrying the appliance with your finger on the switch or energizing appliance that have the switch on invites accidents.

2. Disconnect the battery pack from the appliance before making any adjustments changing accessories or storing appliance. Such preventive safety measures reduce the risk of starting the appliance accidentally.

3. Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack.

4. Use appliances only with specifically designated battery packs. Use of any other battery packs may create a risk of injury and fire.

5. When battery pack is not in use, keep it away from other metal objects, like paper clips, coins, keys, nails, screws or other small metal objects, that can make a connection from one terminal to another. Shorting the battery terminals together may cause burns or a fire.

6. Under abusive conditions, liquid maybe ejected from the battery; avoid contact. If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid ejected from the battery may cause irritation or burns.

7. Do not use a battery pack or appliance that is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion or risk of injury.

8. Do not expose a battery pack or appliance to fire or excessive temperature. Exposure to fire or temperature above 130°C may cause explosion. The temperature of 130°C can be replaced by the temperature of 265 °F.

9. Follow all charging instructions and do not charge the battery pack or appliance outside of the temperature range specified in the instructions. Charging improperly or at temperatures outside of the specified range may damage the battery and increase the risk of fire.

10. Have servicing performed by a qualified repair person using only identical replacement parts. This will ensure that the safety of the product is maintained.

11. Do not modify or attempt to repair the appliance or the battery pack (as applicable) except as indicated in the instructions for use and care.

• If the battery pack becomes exhausted, it should be removed from the product to avoid leakage.

• In the event of the battery pack leaking, do not allow any liquid to come into contact with the skin or eyes.

• If contact has been made, wash the affected area with copious amounts of water and seek medical advice.

• Keep the battery pack out of the reach of children.

• Secondary battery packs need to be charged before use. After extended periods of storage, it may be necessary to charge and discharge the batteries several times to obtain maximum performance.

• Do not leave battery packs on charge for prolonged periods of time.

• Do not use any charger other than that specifically provided for use with the product.

• The supply terminals are not to be short-circuited.

• Do not store above 60°C. Avoid storing in direct sunlight.

• Do not use any battery packs that are not designed for use with the product.

• Do not dispose of the battery pack in a fire.

• Do not crush, puncture, dismantle or otherwise damage the battery pack.

• Do not dismantle, open or shred battery packs.

• Do not expose the battery pack to heat or fire as it may explode.

• Do not subject the battery pack to mechanical shock.

• Do not dispose of the exhausted battery pack in household waste.

• To dispose of the exhausted battery pack, take it to a local recycling station.

• Contact the local government offices for further details.

• This appliance is fitted with a 25.2V 2200mAh Li-ion rechargeable battery.

• Motorized Cleaner Head: Can be connected to the metal tube for daily cleaning on the floor or carpet, or to the main motor for cleaning the trunk.

• Stiff Roller Brush: Can be installed into the cleaner head; Ideal for both hard floors and carpets.

• Retractable Metal Tube: Can be installed into the cleaner head; performs better for corners that are not easy to clean up.

• Long Crevice: For corners and other hard-to-reach places; can be connected to the metal tube to clean spider webs on the ceiling.

• 2-in-1 Brush: Can be switched into a brush or a wide crevice; suitable for fabric surfaces and corners.

• 2-in-1 Cleaning Gadget: The blade end can be used to cut off hair that wrapped around the roller brush; the other brush end can be used to clean dirt inside the dustbin, strainer or cleaner head.

The INSE S190 consists of the following components:

1. Handle

2. Main Motor

3. Main Motor Release Button

4. Retractable Metal Tube

5. Metal Tube Release Button

6. LED Lights

7. Motorized Cleaner Head

8. Push Button

9. Dust Cup Open Button

10. Dust Cup Release Button

11. Battery Pack

12. Battery Locking Button

13. Power Switch

The Key Function Board on the handle includes:

• Lock key

• Gear indicator lamp

• Speed regulation key

1. Insert the tube end into the cleaner head port until you hear a click, make sure the connection is tight. To remove it, press the metal tube release button with one hand, hold the tube with another hand, and then pull it out.

2. Insert the metal tube end into the suction port of the main motor until you hear a click, make sure the connection is tight. To remove it, press the main motor release button with one hand, hold the main motor with another hand, and then pull the handle to remove the main motor from the tube.

1. Preparation

Please check if the battery power is sufficient before using. It’s suggested to charge over 5-6 hours before the first time of use to ensure utmost performance of the product. Choose the attachment you need according to the cleaning area/surface.

2. Start to Work

• 2-1 Press the power switch to turn on the vacuum, second press to turn it off.

• 2-2 Press the button to switch the power mode between MIN, MID and MAX mode.

• 2-3 To use the lock function, press the power switch to turn on the vacuum, push the button, and release the power switch. The vacuum will continue to work. Push the button again to turn the vacuum off. Push it again and the lock function will be invalid.

Please note: This is for household use only. Do not use outdoors or on wet surfaces, and do not immerse in water.

After turning the vacuum off, press the button to release the dustbin cover, dump the dirt, and then close the cover until you hear a click.

For safety, the battery is shipped with a 30% charge. Please fully charge the battery before first use. It takes about 4.5 hours to fully charge from a flat status.

There are two ways to charge the battery:

Way 1: Insert the battery pack into the main motor. Insert the power plug into the battery pack and connect the power adaptor with the power supply.

Way 2: Charge the battery pack separately by connecting the power adaptor directly to it.

• Three solid white lights: full power

• Two solid white lights: medium power

• One solid white light: low power

• One blinking white light: lower than 10% of the total power, needs a recharge

• Three white lights blinking successively: charging

• Three steady lights: charging complete

• The machine cannot be turned on during charging.

• Charge the battery only with the adaptor (30V) provided by INSE.

• When you won’t use the battery for a long time, please store it in a cool dry place. In this situation, please ensure that the battery has been half charged (2 glowing indicator lights).

• If you need an additional battery, please purchase from an authorized distributor of INSE.

• When the Brush motor overcurrent protection or short circuit protection occurs, the machine stops, LED1, LED2, LED3 will flash as running lights at 3HZ for 5 seconds, after which they extinguish. All keys fail during the alarm.

• When the vacuum motor overcurrent protection, short circuit protection or blocking occurs, the machine stops. LED1, LED2 and LED3 will blink synchronously at 3HZ. Other lights will be off after 5 seconds, and all keys will fail during the alarm.

• When the battery pack is abnormal, LED1 blinks at 3HZ synchronously. Other lights are off and will be off after 5 seconds. During the alarm, all keys fail. For example, when discharging, if the cell temperature is higher than 70±3°C.

• When the voltage of the charger is < 30V, it can be charged normally. LED1, LED2, LED3 blink once every second, and the light sequence is from left to right. When the charger voltage is higher than 31.5V, charging stops, and LED1, LED2, LED3 will flash as a horse light for 5 seconds before shutting down.

Actual runtime will vary based on the power mode, battery capacity, attachment, debris amount, and cleaning area/surface.

Please turn off the vacuum before cleaning.

Wipe the surface with a clean cloth; avoid getting water into the inner part of the vacuum.

Do not place the vacuum under direct sunlight or in wet places after cleaning.

1. Unlock the side lock on the underside of the cleaner head, remove the side cover, and take out the roller brush.

2. Use the 2-in-1 cleaning gadget to cut and remove the tangled hair.

IMPORTANT!

1. Please check and clean the High-efficiency filter/HEPA regularly.

2. Please clean the filter in time if the suction performance declines.

3. Please replace the filter/HEPA if it’s broken or cannot maintain the suction performance of the vacuum cleaner.

4. Please do not bend or squeeze the HEPA.

Cleaning Steps:

1. Hold the main motor, press the button to open the dust bin cover, rotate the strainer and filter one by one to take them out.

2. If they are too dirty, you could wash the metal filter and the black mesh with cool water, and clean the HEPA with the cleaning brush.

3. Ensure the strainer and the black mesh are completely dry before refitting.

Possible Causes:

1. Low battery or no battery power

2. There is a blockage

3. The roller brush is tangled by hair

Solutions:

1. Charge the battery.

2. Remove the blockage (check the metal tube and filters).

3. Clean the roller and also remove the side covers to remove the tangled hair.

Possible Cause: Roller brush is tangled by hair.

Solution: Clean the roller and also remove the side covers to remove the tangled hair.

Possible Causes:

1. Dustbin, strainer or filter is full of dust

2. The strainer or filter is not installed

3. There is a blockage

4. The roller brush is tangled by hair

Solutions:

1. Clean the dustbin, strainer or filter; replace the filter if necessary.

2. Install the strainer and filter.

3. Remove the blockage.

Possible Cause: There is a blockage.

Solution: Remove the blockage.

Possible Causes:

1. Wrong adaptor is used

2. Connection between power cord and battery is loose

Solutions:

1. Use the correct adaptor offered by INSE.

2. Make sure the power cord is plugged tightly.