INSE S160 (01) PDF Document

When using your INSE S160, follow these basic precautions:

General Use:

• Do not use near open flames.

• Do not store near heat sources.

• Do not pick up water or liquids, as this may cause electric shock.

• Do not pick up burning objects, flammable liquid, matches, cigarette ends, hot ashes, or any hot, burning, or smoking objects.

• Do not put hands near the brush bar when the machine is in use.

• Do not place the appliance on or near a cooker.

• Do not use to pick up sharp objects such as glass or screws.

• Do not use if any of its openings are blocked.

• Do not use the appliance for anything other than its intended use.

• Do not use if it has been dropped or shows visible signs of damage.

• This appliance is intended for domestic use only. It should not be used for commercial purposes.

Environment and Storage:

• Do not store the appliance in direct sunlight or in high humidity conditions.

• Do not use this appliance outdoors.

• Do not expose the appliance to rain.

Accessories and Power:

• Only use the provided power adapter. Use of an extension power cord is not allowed.

• Do not use any damaged accessories or adaptors.

• Do not use any parts/accessories or adaptors other than those supplied with this appliance, as this may cause damage.

• Do not use the adaptor to recharge non-rechargeable batteries.

• Do not remove the adaptor from the mains power supply by pulling the cord; switch off and remove the plug by hand.

Operation and Maintenance:

• Do not operate the appliance with wet hands.

• Do not immerse the appliance in water or any other liquid.

• Always ensure the appliance has cooled fully after use before performing any cleaning or user maintenance.

• Switch off the appliance and disconnect it from the mains power supply before changing or fitting accessories.

• Take care when equipping accessories with rotating parts as this could cause entrapment.

Supervision and Safety:

• Keep the appliance away from other heat-emitting appliances, heat, or sharp edges.

• Keep away from children aged below 8.

• Children should be supervised to ensure that they do not play with the appliance.

• Children aged 8 years and above, and people with reduced physical, sensory or mental capabilities can use this appliance only if they have been given supervision or instruction concerning its safe use and understand the hazards involved.

• Improper repairs may put the user in danger. If any part is damaged due to human error, only a qualified electrician can repair it.

For your INSE S160, please adhere to the following battery safety rules:

• If the battery pack becomes exhausted, it should be removed from the product to avoid leakage.

• In the event of the battery pack leaking, do not allow any liquid to come into contact with the skin or eyes. If contact has been made, wash the affected area with copious amounts of water and seek medical advice.

• Keep the battery pack out of the reach of children.

• Secondary battery packs need to be charged before use. After extended periods of storage, it may be necessary to charge and discharge the batteries several times to obtain maximum performance.

• Do not leave battery packs on charge for prolonged periods of time.

• Do not use any charger other than that specifically provided for use with the product.

• The supply terminals are not to be short-circuited.

• Do not store above 60°C. Avoid storing in direct sunlight.

• Do not use any battery packs that are not designed for use with the product.

• Do not dispose of the battery pack in a fire.

• Do not crush, puncture, dismantle or otherwise damage the battery pack.

• Do not dismantle, open or shred battery packs.

• Do not expose the battery pack to heat or fire as it may explode.

• Do not subject the battery pack to mechanical shock.

• Do not dispose of the exhausted battery pack in household waste. Take it to a local recycling station.

• This appliance is fitted with a 25.2V 2200mAh Li-ion rechargeable battery.

Read all safety warnings and instructions for your INSE S160. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury.

1. Prevent unintentional starting by ensuring the switch is in the off-position before connecting the battery pack, picking up, or carrying the appliance.

2. Disconnect the battery pack from the appliance before making any adjustments, changing accessories, or storing the appliance.

3. Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack.

4. Use appliances only with specifically designated battery packs. Use of any other battery packs may create a risk of injury and fire.

5. When the battery pack is not in use, keep it away from other metal objects, like paper clips, coins, keys, nails, screws, or other small metal objects, that can make a connection from one terminal to another. Shorting the battery terminals together may cause burns or a fire.

6. Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid ejected from the battery may cause irritation or burns.

7. Do not use a battery pack or appliance that is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion, or risk of injury.

8. Do not expose a battery pack or appliance to fire or excessive temperature. Exposure to fire or temperature above 130°C (265°F) may cause an explosion.

9. Follow all charging instructions and do not charge the battery pack or appliance outside of the temperature range specified in the instructions. Charging improperly or at temperatures outside of the specified range may damage the battery and increase the risk of fire.

10. Have servicing performed by a qualified repair person using only identical replacement parts to ensure the safety of the product is maintained.

11. Do not modify or attempt to repair the appliance or the battery pack (as applicable) except as indicated in the instructions for use and care.

The INSE S160 comes with the following parts and accessories:

• Main Motor: The main vacuum unit containing the motor and dust cup.

• Metal Filter: A reusable filter inside the dust cup.

• Wall Bracket: For storing the vacuum cleaner.

• Power Adaptor: For charging the battery.

• Retractable Metal Tube: Connects the main motor to the cleaner head.

• Stiff Roller Brush: Can be installed into the cleaner head; ideal for both hard floors and carpets.

• Motorized Cleaner Head: Attaches to the metal tube for daily floor cleaning or directly to the main motor for cleaning smaller areas like a car trunk.

• HEPA Filter: Installed in the motor for high-efficiency filtration.

• Battery Pack: The removable, rechargeable power source.

• 2-in-1 Brush: Can be switched between a brush and a wide crevice tool, suitable for fabric surfaces and corners.

• Pre-Filter x 2: One is pre-installed in the dustbin.

• Long Crevice: For corners and other hard-to-reach places; can be connected to the metal tube to clean high areas like spider webs.

• 2-in-1 Cleaning Gadget: The blade end cuts hair from the roller brush, and the brush end cleans the dustbin, strainer, or cleaner head.

• Quick Start Guide & User Manual

Actual accessories may vary from shown or change without notice. Available accessories may vary by market.

The main components of the INSE S160 vacuum are:

1. Handle

2. Main Motor

3. Main Motor Release Button

4. Retractable Metal Tube

5. Metal Tube Release Button

6. LED Lights (on the cleaner head)

7. Motorized Cleaner Head

8. Push Button

9. Dust Cup Open Button

10. Dust Cup Release Button

11. Battery Pack

12. Battery Locking Button

13. Power Switch

Key Function Board:

a. Lock key

b. Gear indicator lamp

c. Speed regulation key

1. Attach the Cleaner Head to the Tube: Insert the tube end into the cleaner head port until you hear a click. To remove it, press the metal tube release button with one hand, hold the tube with the other, and pull it out.

2. Attach the Tube to the Main Motor: Insert the metal tube end into the suction port of the main motor until you hear a click. To remove it, press the main motor release button with one hand, hold the main motor with the other, and pull the handle to remove the main motor from the tube.

You can also attach accessories like the 2-in-1 Brush or Long Crevice directly to the main motor or to the end of the metal tube.

1. Preparation:

Check if the battery power is sufficient. It’s suggested to charge for over 5-6 hours before the first use to ensure the best performance. Choose the appropriate attachment for the cleaning area/surface.

2. Start to Work:

• 2-1: Press the power switch to turn the vacuum on. Press it a second time to turn it off.

• 2-2: Press the speed regulation button to switch the power mode between MIN, MID, and MAX mode.

• 2-3 (Lock Function): To keep the vacuum running without holding the switch, press the power switch to turn it on, then push the lock button. The vacuum will continue to work. Push the lock button again to turn the vacuum off. If you push the lock button again while it is active, the lock function will become invalid.

Important Usage Notes:

• HOUSEHOLD USE ONLY

• DO NOT use outdoors or on wet surfaces

• DO NOT immerse in water

After turning the vacuum off, press the dust cup open button to release the dustbin cover. Dump the dirt and then close the cover firmly until you hear a click.

The battery is charged to about 30% capacity before shipping for safety. Please fully charge the battery before first use. It takes about 4.5 hours to fully charge from a flat status.

There are two ways to charge the battery:

• Way 1 (Charging in the vacuum): Insert the battery pack into the main motor. Insert the power plug into the battery pack and connect the power adaptor to a power supply.

• Way 2 (Charging separately): Remove the battery pack from the main motor. Insert the power plug directly into the battery pack and connect the power adaptor to a power supply.

During Operation (On Work):

• Three solid white lights: Full power

• Two solid white lights: Medium power

• One solid white light: Low power

• One blinking white light: Lower than 10% of total power, needs a recharge

During Charging:

• Three white lights blinking successively: Charging in progress

• Three steady lights: Charging complete

• The machine cannot be turned on during charging.

• Charge the battery only with the adaptor (30V) provided by INSE.

• When not using the battery for a long time, store it in a cool, dry place. Ensure the battery is half-charged (2 glowing indicator lights).

• If you need an additional battery, purchase it from an authorized distributor of INSE.

• Brush motor error: If there is overcurrent or short circuit protection for the Brush motor, the machine stops. LED1, LED2, and LED3 will become running lights at 3HZ. After 5 seconds, the lights will extinguish, and all keys will fail during the alarm.

• Vacuum motor error: If there is overcurrent, short circuit protection, or blocking of the vacuum motor, the machine stops. LED1, LED2, and LED3 will blink synchronously at 3HZ. Other lights will turn off after 5 seconds, and all keys will fail during the alarm.

• Battery pack abnormal: LED1 will blink at 3HZ synchronously. Other lights are off and will turn off after 5 seconds. All keys fail during the alarm. An example is when the cell temperature is higher than 70±3°C during discharging.

• Charger voltage issue: When the charger voltage is < 30V, it can be charged normally, with LED1, LED2, LED3 blinking once every second from left to right. If the charger voltage is higher than 31.5V, charging stops, LED1, LED2, LED3 lights run like a horse light, and the machine shuts down after 5 seconds.

To ensure maximum performance, regularly maintain your INSE S160. WARNING: The dustbin or the cleaner head cannot be washed by water. Otherwise, the motors will be damaged.

Clean Handheld Part of the Main Motor:

1. Please turn off the vacuum before cleaning.

2. Wipe the surface with a clean cloth; avoid getting water into the inner part of the vacuum.

3. Do not place the vacuum under direct sunlight or in wet places after cleaning.

Clean Dust Cup:

The sign -MAX- on the dust cup indicates the dust capacity limit. Once the dust approaches this sign, empty the dust cup in time. You can use the 2-in-1 cleaning gadget to clean the inside.

1. Unlock the side lock on the underside of the cleaner head, remove the side cover, and take out the roller brush.

2. Use the 2-in-1 cleaning gadget to cut and remove the tangled hair.

IMPORTANT!

1. Please check and clean the High-efficiency filter/HEPA regularly.

2. Please clean the filter in time if the suction performance declines.

3. Please replace the filter/HEPA if it’s broken or cannot maintain the suction performance of the vacuum cleaner.

4. Please do not bend or squeeze the HEPA.

Cleaning Steps:

1. Hold the main motor, press the button to open the dust bin cover. Rotate the strainer and filter one by one to take them out.

2. If they are too dirty, you can wash the metal filter and the black mesh with cool water. Clean the HEPA with the cleaning brush.

3. Ensure the strainer and the black mesh are completely dry before refitting.

Note on Runtime: Any runtime posted is the time when the machine runs without attaching to any surface and debris. Actual runtime will vary based on the power mode, battery capacity, attachment, debris amount, and cleaning area/surface.