INSE S150 (01) PDF Document

When using your INSE S150, you should always follow basic precautions. Please read all instructions and cautionary markings before use.

General Safety:

• Do not use near open flames.

• Do not store near heat sources.

• Do not pick up water or other liquids, as this may cause an electric shock.

• Do not pick up burning objects.

• Do not put your hands near the brush bar when the machine is in use.

• Do not place the appliance on or near a cooker.

• Do not pick up sharp objects such as glass or screws.

• Do not use the appliance to pick up flammable liquid, matches, cigarette ends, hot ashes, or any hot, burning, or smoking objects.

• Do not use if any of its openings are blocked.

• Do not store the appliance in direct sunlight or in high humidity conditions.

• Do not use this appliance outdoors or on wet surfaces.

• Do not use any damaged accessories or adaptors.

• Only use parts, accessories, or adaptors supplied with this appliance.

• Do not use the appliance for anything other than its intended use.

• Do not use the appliance if it has been dropped or if there are visible signs of damage.

• Do not use the adaptor to recharge non-rechargeable batteries.

• To unplug, switch off and remove the plug by hand; do not pull the cord.

• Do not expose the appliance to rain or operate it with wet hands.

• Do not immerse the appliance in water or any other liquid.

• Only use the provided power adapter. The use of an extension cord is not allowed.

• Ensure the appliance has cooled fully before cleaning or maintenance.

• Switch off and disconnect from the main power supply before changing or fitting accessories.

• Be careful when equipping accessories with rotating parts to avoid entrapment.

• This appliance is intended for domestic use only, not for commercial purposes.

• Keep the appliance away from other heat-emitting appliances and sharp edges.

• Keep away from children under 8 years old. This appliance is not a toy.

• Check that the voltage on the rating plate matches your power supply voltage.

• If the battery pack becomes exhausted, it should be removed from the product to avoid leakage.

• In the event of a battery pack leak, do not allow any liquid to contact the skin or eyes. If contact occurs, wash the affected area with copious amounts of water and seek medical advice.

• Keep the battery pack out of the reach of children.

• Secondary battery packs need to be charged before use. For maximum performance after long storage, it may be necessary to charge and discharge the batteries several times.

• Do not leave battery packs on charge for prolonged periods.

• Do not use any charger other than the one specifically provided for the product.

• The supply terminals must not be short-circuited.

• Do not store above 60°C. Avoid storing in direct sunlight.

• Do not use any battery packs not designed for this product.

• Do not dispose of the battery pack in a fire.

• Do not crush, puncture, dismantle, or otherwise damage the battery pack.

• Do not dismantle, open, or shred battery packs.

• Do not expose the battery pack to heat or fire as it may explode.

• Do not subject the battery pack to mechanical shock.

• Do not dispose of the exhausted battery pack in household waste. Take it to a local recycling station.

• This appliance is fitted with a 25.2V 2200mAh Li-ion rechargeable battery.

Read all safety warnings and instructions. Failure to follow them may result in electric shock, fire, and/or serious injury.

1. Prevent unintentional starting by ensuring the switch is in the off-position before connecting the battery pack, picking up, or carrying the appliance.

2. Disconnect the battery pack before making adjustments, changing accessories, or storing the appliance to reduce the risk of accidental starting.

3. Recharge only with the charger specified by the manufacturer. A charger suitable for one type of battery pack may create a risk of fire when used with another battery pack.

4. Use appliances only with specifically designated battery packs. Use of any other battery packs may create a risk of injury and fire.

5. When the battery pack is not in use, keep it away from other metal objects (like paper clips, coins, keys, nails, screws) that can make a connection from one terminal to another. Shorting the battery terminals may cause burns or a fire.

6. Under abusive conditions, liquid may be ejected from the battery. Avoid contact. If contact occurs, flush with water. If liquid contacts eyes, seek medical help. Liquid from the battery may cause irritation or burns.

7. Do not use a battery pack or appliance that is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion, or risk of injury.

8. Do not expose a battery pack or appliance to fire or excessive temperature. Exposure to fire or temperatures above 130°C (265°F) may cause an explosion.

9. Follow all charging instructions. Do not charge the battery pack or appliance outside the temperature range specified in the instructions. Charging improperly or outside the specified range may damage the battery and increase the risk of fire.

10. Have servicing performed by a qualified repair person using only identical replacement parts to ensure the product’s safety is maintained.

11. Do not modify or attempt to repair the appliance or the battery pack except as indicated in the instructions for use and care.

The INSE S150 comes with several accessories for versatile cleaning. Actual accessories may vary.

• Motorized Cleaner Head: Can be connected to the metal tube for daily cleaning on floors or carpets, or directly to the main motor for cleaning areas like a car trunk.

• Stiff Roller Brush: Installed into the cleaner head. Ideal for both hard floors and carpets.

• Retractable Metal Tube: Can be installed into the cleaner head; performs better for corners that are not easy to clean up.

• Long Crevice: For corners and other hard-to-reach places. It can be connected to the metal tube to clean spider webs on the ceiling.

• 2-in-1 Brush: Can be switched between a brush and a wide crevice tool. Suitable for fabric surfaces and corners.

• 2-in-1 Cleaning Gadget: The blade end is used to cut hair wrapped around the roller brush. The other brush end can be used to clean dirt inside the dustbin, strainer, or cleaner head.

The main components are:

1. Handle

2. Main Motor

3. Main Motor Release Button

4. Retractable Metal Tube

5. Metal Tube Release Button

6. LED Lights

7. Motorized Cleaner Head

8. Push Button

9. Dust Cup Open Button

10. Dust Cup Release Button

11. Battery Pack

12. Battery Locking Button

13. Power Switch

Key Function Board:

• Lock key

• Gear indicator lamp

• Speed regulation key

1. Attach Cleaner Head to Tube: Insert the tube end into the cleaner head port until you hear a click, ensuring the connection is tight. To remove it, press the metal tube release button with one hand, hold the tube with the other hand, and pull it out.

2. Attach Tube to Main Motor: Insert the metal tube end into the suction port of the main motor until you hear a click, ensuring the connection is tight. To remove it, press the main motor release button with one hand, hold the main motor with the other hand, and pull the handle to remove the main motor from the tube.

3. Storage: The whole machine can be hung onto the wall bracket for storage.

1. Preparation:

Check if the battery power is sufficient. It’s suggested to charge for over 5-6 hours before the first use. Choose the appropriate attachment for the cleaning area.

2. Start to Work:

• Power On/Off: Press the power switch to turn the vacuum on. Press it a second time to turn it off.

• Switch Power Mode: Press the button to switch the power mode between MIN, MID, and MAX mode.

• Lock Function: Press the power switch to turn the vacuum on, then push the lock button and release the power switch. The vacuum will continue to work. Push the lock button again to turn the vacuum off. Pushing it again will invalidate the lock function.

Important Usage Notes:

• HOUSEHOLD USE ONLY.

• DO NOT use outdoors or on wet surfaces.

• DO NOT immerse in water.

3. Dust Cup Cleaning:

After turning the vacuum off, press the button to release the dustbin cover. Dump the dirt and then close the cover until you hear a click.

For safety, the battery is shipped with about 30% charge. Please fully charge the battery before first use. It takes about 4.5 hours to fully charge from a flat status.

There are two ways to charge the battery:

Way 1: Charge the battery in the main motor

Insert the battery pack into the main motor. Insert the power plug into the battery pack and connect the power adaptor to the power supply.

Way 2: Charge the battery separately

Charge the separate battery directly by connecting the power adaptor to it.

During Operation (On Work):

• Three solid white lights: Full power

• Two solid white lights: Medium power

• One solid white light: Low power

• One blinking white light: Lower than 10% of total power, needs a recharge

During Charging:

• Three white lights blinking successively: Charging

• Three steady lights: Charging complete

• The machine cannot be turned on during charging.

• Charge the battery only with the adaptor (30V) provided by INSE.

• When not using the battery for a long time, store it in a cool, dry place. Ensure the battery is half-charged (2 glowing indicator lights).

• If you need an additional battery, purchase one from an authorized INSE distributor.

• Brush Motor Error: If there is overcurrent or short circuit protection for the brush motor, the machine stops. LED1, LED2, and LED3 will flash as running lights at 3HZ for 5 seconds, after which they extinguish. All keys will fail during the alarm.

• Vacuum Motor Error: If there is overcurrent, short circuit protection, or blocking for the vacuum motor, the machine stops. LED1, LED2, and LED3 will blink synchronously at 3HZ for 5 seconds, after which other lights will turn off. All keys will fail during the alarm.

• Battery Pack Error: If the battery pack is abnormal (e.g., cell temperature higher than 70±3°C during discharging), LED1 will blink at 3HZ synchronously for 5 seconds. Other lights will be off. All keys will fail during the alarm.

• Charger Voltage Error: When charger voltage is < 30V, it charges normally (LEDs blink once per second from left to right). If charger voltage is > 31.5V, charging stops, and the LEDs run a horse light sequence for 5 seconds before shutting down.

To ensure maximum performance, regularly maintain the vacuum’s components. Important: The dustbin or the cleaner head cannot be washed by water. Otherwise, the motors will be damaged.

Clean Handheld Part of the Main Motor:

• Please turn off the vacuum before cleaning.

• Wipe the surface with a clean cloth; avoid water getting into the inner part of the vacuum.

• Do not place the vacuum under direct sunlight or in wet places after cleaning.

Clean Dust Cup:

The sign -MAX- on the dust cup indicates the dust capacity limit. Once the dust approaches the sign, empty the dust cup in time. You can use the 2-in-1 cleaning gadget to clean the inside.

Clean Detachable Roller Brush:

1. Unlock the side lock on the underside of the cleaner head, remove the side cover, and take out the roller brush.

2. Use the 2-in-1 cleaning gadget to cut and remove the tangled hair.

IMPORTANT!

1. Please check and clean the High-efficiency filter/HEPA regularly.

2. Please clean the filter in time if the suction performance declines.

3. Please replace the filter/HEPA if it’s broken or cannot maintain the suction performance.

4. Please do not bend or squeeze the HEPA.

Cleaning Steps:

1. Hold the main motor and press the button to open the dust bin cover. Rotate the strainer and filter one by one to take them out.

2. If they are too dirty, you can wash the metal filter and the black mesh with cool water. Clean the HEPA with the cleaning brush.

3. Ensure the strainer and the black mesh are completely dry before refitting.

Note on Runtime: Any posted runtime is the time when the machine runs without attaching to any surface and debris. Actual runtime will vary based on the power mode, battery capacity, attachment, debris amount, and cleaning area/surface.