HAIER BD-103G (01) PDF Document

Before using your HAIER BD-103G, please observe the following important safety warnings:

Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.

Do not use mechanical devices or other means to accelerate the defrosting process other than those recommended by the manufacturer.

Do not damage the refrigerant circuit.

Do not use electrical appliances inside the food storage compartment of the appliance, unless they are of the type recommended by the manufacturer.

This appliance is designed for domestic use. If installed for professional or commercial use, the standards applicable to the respective trade must be observed.

If you are replacing an old appliance, it is essential to destroy any existing latch- or bolt-locks on the old appliance before you put it aside to prevent playing children from locking themselves in.

After installation of the appliance, the plug should be easily accessible.

If the power cable is damaged, an approved cable provided by a manufacturer or a service agent must be used for replacement.

To properly install your HAIER BD-103G, follow these guidelines:

1. Strictly avoid high ambient temperatures and direct sunlight. Place your appliance in a cool, well-aired, dry room.

2. Avoid installing the freezer near a heat source like a heater or oven. If installation near a heat source is unavoidable, fit a suitable insulation plate between the appliance and the heat source (do not use asbestos) and observe the following minimum distances:

– From a gas or electric cooker: 3 cm

– From a radiator or oven: 5 cm

– From a wall, piece of furniture, or another appliance: 2 cm

3. If your HAIER BD-103G model has a ventilation grille, never obstruct it. You can place the appliance directly against a wall or furniture, but not with the side protected by the ventilation grille.

4. If your model does not have a ventilation grille, leave sufficient space between the rear of the appliance and the wall to allow warm air to escape.

5. The appliance must be placed horizontally and on a level base to ensure an unimpeded refrigerant circuit and optimum function.

IMPORTANT: After placing the freezer in its final position, leave it to stand for at least 2 hours before switching it on. This allows the refrigerant circuit to stabilize and prevents operating problems.

1. Fully unpack the appliance.

2. Remove the polystyrene parts in the compressor chamber (if supplied).

3. Remove documents and any accessories from the inside of the appliance.

4. Clean the interior with a mixture of lukewarm water and vinegar, and dry thoroughly with a cloth.

5. Close the appliance.

6. Insert the plug into the socket.

7. Switch on the appliance by turning the temperature control to the right. For the time being, turn the controller fully to the right to the Max position (the green and red lights will go on).

8. If equipped with a SUPER FREEZE SWITCH, turn it on (the yellow light will also go on).

9. Do not open the appliance for about 4 hours, or for as long as the red light is on, to allow the interior temperature to drop to the necessary level.

10. You can now fill the appliance with any amount of deep-frozen food (purchased ready-frozen goods).

11. Turn off the SUPER FREEZE SWITCH again after 24 hours at the latest.

12. If you wish to freeze fresh, unfrozen food, proceed as instructed in the manual.

The temperature control on your HAIER BD-103G switches the appliance on and off and sets the cooling temperature. The control is intentionally resistant to turning to prevent accidental changes. To adjust the setting, it is recommended to use a coin or a screwdriver.

The compressor will stop when the control panel marking is on position “0” or “OFF” (not all models have this function).

The temperature is factory preset for satisfactory food storage. However, you can adjust it for your personal satisfaction between:

Min. / minimum number: for slight cooling.

Max. / maximum number: for the lowest temperature.

Temperature settings should be based on the ambient temperature, the quantity of stored food, and the frequency of opening. A medium setting is recommended.

If your HAIER BD-103G is equipped with indicator lights, they signify the following:

green = CONTROL

This light indicates that the appliance is connected to the mains power and is operating. The green light must always be on when the appliance is plugged in and switched on. It is an important indicator, as in a power failure, the red and yellow lights stop working and no longer provide a warning.

red = ALARM

This light indicates that the interior temperature is too high. This is normal during the first start-up, after defrosting, or when filling the freezer with fresh food. The light will go off automatically when the interior temperature reaches approximately -15°C. If the red light stays on for more than 12 to 24 hours, there may be a serious problem.

yellow = SUPER FREEZE SWITCH is on

This light indicates that the SUPER FREEZE function is active, and the thermostat function is disabled. The compressor will continue cooling until the SUPER FREEZE switch is turned off.

Almost all fresh products are suitable for freezing. Pack them in portions suitable for your household. Label the portions with at least the product name, weight, quantity, freezing date, and use-by date.

Then continue as follows:

a) Place fresh foods in the pre-freezing compartment at the side or on the bottom of the freezer, which is the coldest part. Avoid putting fresh foods in direct contact with already deep-frozen food.

b) Within 24 hours, only fill with quantities of fresh food suitable for the freezing capacity of your appliance (see the rating plate for XX kg/24h).

c) If available, switch on the SUPER FREEZE SWITCH.

d) After 24 hours, move the now deep-frozen goods from the freezer bottom or pre-freeze shelf to a hanging basket to make space for freezing additional fresh foods.

e) Turn off the SUPER FREEZE SWITCH (the yellow light will go off).

f) Set the temperature control according to the appliance’s filling capacity.

g) Keep the temperature in the storage shelf under control. The storage temperature must always be at least -18°C.

To ensure correct storage of frozen food, never fill the storage shelf up to the edge. Always allow space between the lid and the frozen foods.

To save energy when operating in a normal ambient temperature (+18°C to +22°C), set the temperature control according to the filling capacity as follows:

Under normal conditions (3 to 4 openings per day), your HAIER BD-103G must be defrosted once or twice a year. Never use electrical appliances like hair dryers or devices with a naked flame to defrost the freezer.

Proceed as follows:

1. Provide a suitable non-metallic container (e.g., a plastic container or wash-basket).

2. Make absolutely sure that you remove the plug from the power socket.

3. Dry your hands thoroughly to prevent skin damage from contact with ice (it is advisable to use gloves).

4. Remove all frozen food from the freezer, roll it firmly in newspaper, place it in the container, and put the container in a cool, dry room.

5. Cover the container all around with a thick blanket.

6. Lift the divider (if equipped) upwards out of the guide rail.

7. Use the divider (if provided) as a defrosting dish and push it on the side under the freezer where the defrosting water drain plug is located.

8. Pull the drain plug (if provided) out of the freezer bottom.

9. Scrape the thickest ice carefully from the freezer inside using a plastic or wood scraper without sharp edges and put it into the kitchen sink.

10. If necessary, speed up defrosting by placing a large pot of warm (not too hot) water on the freezer bottom.

11. In freezers without a drain plug, continuously wipe up the water with a sponge.

12. Thoroughly clean the inside with a mixture of warm water and vinegar, then rinse with clear water.

13. Wipe the freezer with an absorbent cloth and allow it to air for about 3 to 4 minutes.

14. Replace the drain plug (if provided).

15. Empty the defrosting water dish (if provided) and slide it back as a divider into the guide rails.

16. Close the chest and plug it back into the socket.

17. Set the temperature control to the maximum setting (green and red lamps will go on) and switch on the SUPER FREEZE SWITCH (if provided) (the yellow lamp will light up additionally).

18. Now refill the frozen food, placing the oldest items at the top.

19. When the red lamp goes off, reset the temperature control as per the filling capacity.

20. Switch off the SUPER FREEZER SWITCH (if provided) after about 8 to 12 hours, or at the latest after 24 hours (the yellow light will go off).

If your HAIER BD-103G is not running, first note that during a power failure, the insulation of the appliance walls provides 10 to 12 hours of storage time for frozen food. If the problem will take longer to eliminate, take prompt action and, if necessary, shift the frozen food into another freezer.

If your HAIER BD-103G is not cooling sufficiently or the compressor is operating too often, check the following possible causes and remedies:

Did you let the appliance stand for at least 2 hours before switching it on? If not, unplug the chest, lift it for a brief moment and put it back down. After 2 hours, plug it back in. Do not open the chest for a further 12 hours, or until the red light goes off.

Is the plug in good condition and properly plugged into the socket? Check the plug and connection.

Is the socket under current? Test the socket by connecting a small appliance like a hand-mixer.

Does the lid of the appliance close properly and the seal press firmly? Test the seal by placing a piece of paper between the seal and the edge of the chest and closing the lid. It should be difficult to pull the paper out from any side. If you can pull the paper out without resistance, notify your after-sales service.

Is there heavy ice formation on the inner walls? If so, the freezer needs to be defrosted.

Is the appliance exposed to direct sunlight or installed near a heat source? Protect the appliance from direct sunlight, check the distance to the heat source, and if necessary, place an isolating plate.

Did you overfill the freezer or fill it with warm food? The amount of food should not exceed the freezing capacity of your appliance (see rating plate: XXkg/24h), and you should not add too much warm food at once.

The following table provides approximate storage times for various foods in your HAIER BD-103G: