HAIER BD-520 (01) PDF Document

Please observe the following important safety warnings when using your HAIER BD-520 Chest Freezer:

Ventilation: Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.

Defrosting: Do not use mechanical devices or other means to accelerate the defrosting process other than those recommended by the manufacturer.

Refrigerant Circuit: Do not damage the refrigerant circuit. Interventions on the cooling system must be carried out by professional and authorized personnel only. Escaping refrigerant can injure your eyes. In the event of eye contact with the refrigerant, wash your eyes instantly under plenty of running water and consult an eye specialist immediately.

Electrical Appliances: Do not use electrical appliances inside the food storage compartment of the appliance, unless they are of the type recommended by the manufacturer.

Old Appliances: If you are replacing an old appliance, it is essential to destroy any existing latch- or bolt-locks on the old appliance before you put it aside to prevent playing children from locking themselves in. Please have the old appliance ecologically disposed of by a company specialized in environmental protections.

Power Cable: If the power cable is damaged, an approved cable provided by a manufacturer or a service agent must be used for replacement.

Accessibility: After installation of the appliance, the plug should be easily accessible.

To ensure proper installation of your HAIER BD-520, please follow these guidelines:

1. Choose a suitable position: Place your appliance in a cool, well-aired, dry room. Strictly avoid high ambient temperatures and direct sunlight. Do not install it in the immediate vicinity of a heat source like a heater or oven.

2. Maintain minimum distances from heat sources: If installation near a heat source is unavoidable, use a suitable insulation plate and observe the following minimum distances:

– From a gas or electric cooker: 3 cm

– From a radiator or oven: 5 cm

– From a wall, piece of furniture, or another appliance: 2 cm

3. Do not obstruct the ventilation grille: If your freezer has a ventilation grille (F) on one side, it can be placed directly against a wall, but not with the side with the grille obstructed.

4. Ensure proper airflow: For freezers without a ventilation grille, leave sufficient space between the rear of the appliance and the wall to allow warm air to escape.

5. Level the appliance: The appliance must be placed horizontally and on a level base to ensure an unimpeded circuit of the refrigerant and optimum function.

IMPORTANT: Leave the HAIER BD-520 to stand in its final position for at least 2 hours before switching it on. This allows the refrigerant circuit to stabilize and prevents operating problems.

Before first use, thoroughly clean the interior compartment with a mixture of lukewarm water and vinegar to remove the typical new appliance odor. Do not use washing liquids, sharp or granular cleaning implements, or any cleaning products containing soda. Before connecting the appliance, make sure the inner area, especially the corners, is absolutely dry.

The temperature control (thermostat) switches the appliance on and off and sets the cooling temperature. The control is intentionally resistant to turning to prevent accidental changes. To vary the setting, it is recommended to use a coin or a screwdriver.

The settings range between:

Min / minimum number: for slight cooling.

Max / maximum number: for the lowest temperature.

The compressor will stop when the control panel marking is on position “0” or “OFF” (not all models have this function).

Temperature settings should be adjusted according to:

– Ambient temperature of the appliance

– Quantity of stored foodstuff

– Frequency of opening

A medium setting is recommended for general use.

The indicator lights on your HAIER BD-520 provide important information about its status:

GREEN (CONTROL): This light indicates that the appliance is connected to power and is operating. The green control light must always be on when the appliance is switched on.

RED (ALARM): This light indicates that the interior temperature is too high. It is normal for this light to be on during the first start-up, after defrosting, or when filling the freezer with fresh food. It should go off automatically when the interior temperature reaches approximately -15°C. If the red light stays on for more than 12 to 24 hours, there may be a serious problem.

YELLOW (SUPER FREEZE): This light indicates that the SUPER FREEZE switch is on. When activated, the thermostat function is disabled, and the compressor cools continuously. This function is used for freezing fresh food quickly.

Please follow these steps to start your HAIER BD-520 correctly:

1. Fully unpack the appliance.

2. Remove the polystyrene parts in the compressor chamber (if supplied).

3. Remove documents and any accessories from the inside of the appliance.

4. Clean the interior with a mixture of lukewarm water and vinegar, and dry thoroughly with a cloth.

5. Close the appliance.

6. Insert the plug into the socket.

7. Switch on the appliance by turning the temperature control to the right. For the time being, turn the controller fully to the right to the Max position (green and red lights will go on).

8. If equipped with a SUPER FREEZE SWITCH, turn it on (the yellow light will go on too).

9. Do not open the appliance for about 4 hours, or for as long as the red light is on, to allow the interior temperature to drop to the necessary level.

10. You can now fill the appliance with any amount of deep-frozen food (purchased ready-frozen goods).

11. Turn off the SUPER FREEZE SWITCH again after 24 hours at the latest.

12. If you wish to freeze fresh, unfrozen food, proceed to the instructions for “Freezing/storage of fresh food”.

To properly freeze and store fresh food, follow these steps:

1. Pack fresh products in portions suitable for your household. Use appropriate packaging like freezer bags or aluminum foil.

2. Label the portions with at least the following information:

– Product name (e.g., beef fillet)

– Weight of portion

– Quantity (total of pieces)

– Freezing date

– Use-by date (consumption date)

3. Then continue as follows:

a) Place fresh foods in the pre-freezing compartment at the side or on the bottom of the freezer, which is the coldest part. Avoid putting fresh foods in direct contact with already deep-frozen food.

b) Within 24 hours, fill in only the quantity of fresh food that is suitable for the freezing capacity of your appliance (see information on the rating plate, XX kg/24h).

c) If available, switch on the SUPER FREEZE SWITCH.

d) After 24 hours, shift the now deep-frozen goods from the freezer bottom or pre-freeze shelf to a hanging basket, making the space available for more fresh food.

e) Turn off the SUPER FREEZE SWITCH (the yellow light will go off).

f) Set the temperature control according to the filling capacity.

g) Keep the temperature in the storage shelf under control. The storage temperature must always be at least -18°C.

To ensure correct storage and save energy when operating in normal ambient temperatures (+18 to +22°C), we recommend the following settings for the temperature control based on the filling capacity. Always allow space between the lid and the frozen foods; never fill the storage shelf up to the edge.

For proper upkeep of your HAIER BD-520, follow these cleaning and maintenance procedures:

Exterior: For the external appearance, now and again clean with furniture polish or another enamel protecting product. Never use it on the inside.

Lid Seal: Clean the seal with warm water now and again without using any cleaning product.

Condenser: If your appliance has a condenser in the rear, from time to time remove dirt and dust. Dust and dirt impede the release of heat and increase energy consumption. For best results, use a light brush or duster to remove dust from the condenser on the rear wall.

Long-term absence: If you leave your appliance out of use for an extended period (e.g., when on holidays), leave it open to prevent odors from building up inside.

Removing Ice: When ice and frost layers form, they must be removed from time to time. To remove ice from the inner walls, use a plastic or wood scraper without sharp edges. Cover the frozen food with a cloth to help collect the scraped ice.

Under normal conditions (3 to 4 openings per day), the freezer should be defrosted once or twice a year. Before starting, be aware of these danger warnings: Never use electrical appliances like a hair dryer or devices with a naked flame (e.g., candles) to defrost the chest freezer.

Proceed as follows:

1. Provide a suitable non-metallic container (e.g., plastic container or wash-basket).

2. Make absolutely sure that you remove the plug from the power socket.

3. Dry your hands thoroughly to prevent skin damage from contact with ice (it is advisable to use gloves).

4. Remove all frozen food from the freezer, roll it firmly in newspaper, put it into the container, and place the container in a cool, dry room.

5. Cover the container all around with a thick blanket.

6. Lift the divider (H) upwards out of the guide-rail of the freezer (if equipped).

7. Use the divider as a defrosting dish and push it on the side under the freezer where the defrosting water drain-plug is located.

8. Pull the plug out of the freezer bottom (if provided).

9. Scrape the thickest ice carefully from the freezer inside and put it into the kitchen sink for defrosting.

10. If necessary, speed up defrosting by placing a large pot of warm (not too hot) water on the freezer bottom.

11. In freezers not provided with a drain-plug, continuously wipe up the water with a sponge.

12. Thoroughly clean the inside. Rinse it with a mixture of warm water and vinegar, then rinse with clear water.

13. Wipe the freezer with an absorbent cloth, dry thoroughly, and allow it to air for about 3 to 4 minutes.

14. Replace the drain-plug (if provided).

15. Empty the defrosting water dish and slide it back as a divider into the guide rails of the freezer.

16. Close the chest and plug it back into the socket.

17. Set the temperature control to the maximum setting (green and red lamps will go on) and switch on the SUPER FREEZE SWITCH (if provided) (the yellow lamp will light additionally).

18. Now refill the frozen food, placing the oldest items at the top. This entire process (steps 1 to 17) should be completed within a maximum of two hours to prevent food from defrosting.

19. When the red lamp goes off, reset the temperature control to a setting suitable for the filling capacity.

20. Switch off the SUPER FREEZER SWITCH (if provided) after about 8 to 12 hours, or at the latest after 24 hours (the yellow light will go off).

Yes, certain noises are normal and do not indicate a functional problem with your HAIER BD-520. The compressor (motor) is controlled by the thermostat and does not operate continuously. Noise can be heard in every compressor-cooling system when the compressor is switched on. This noise is produced when the motor in the compressor operates and also by refrigerant flowing in the cooling system circuit. These noises are normal.

If your HAIER BD-520 has no function (is not running), check the following possible causes and remedies:

1. Has the appliance stood for at least 2 hours before switching it on? The refrigerant circuit needs time to stabilize. If not, unplug the freezer, wait, and follow the start-up procedure. Do not open the chest for at least 14 hours after plugging it back in, or until the red light goes off.

2. Is the plug in good condition and properly plugged into the socket? Ensure the plug is fully inserted.

3. Is the socket under current? Test the socket by connecting a small appliance, such as a hand-mixer, to see if it works.

If you are experiencing cooling issues with your HAIER BD-520, check these possible causes and remedies:

1. Does the lid close properly? The seal must press firmly. Test by placing a piece of writing paper between the seal and the edge of the chest and closing the lid. It should be difficult to pull the paper out from any side. If you can pull the paper out without resistance from one or more sides, the seal may be faulty.

2. Is there heavy ice formation on the inner walls? Excessive ice acts as insulation and reduces cooling efficiency. Defrost the appliance.

3. Is the appliance exposed to direct sunlight or near a heat source (oven, radiator)? Protect the appliance from direct sunlight and check the distance to the heat source. If necessary, place an isolating plate between the freezer and the heat source.

4. Was too much warm food added at once? The amount of food added should not exceed the freezing capacity listed on the rating plate (XXkg/24h).

The following table provides approximate storage times in months for different types of food when stored in your HAIER BD-520. Always observe the producer’s instructions on packaging for purchased deep-frozen products.