GODOX C01 KIT2 (01) PDF Document

The main features of the GODOX C01 KIT2 include:

• Maximum 200m stable wireless transmission.

• Clear and stable recording with a noise cancellation function.

• The transmitter provides 9 hours of battery life, which can be extended to 27 hours with the charging case (when paired with two transmitters).

• The receiver supports being used while the phone is charging.

• It offers 48kHz/24bit high-quality sound.

• The transmitter is very lightweight, weighing only 7g.

Please adhere to the following safety warnings:

• This product is a high-precision instrument; please avoid dropping, collision, or pounding.

• Do not disassemble, modify, or attempt to repair this product without permission.

• If repairs are necessary, this product must be sent to an authorized maintenance center.

• Keep the product out of reach of children.

• Do not use in flammable or explosive environments.

• There is a danger of explosion if the battery is not replaced properly. Replace it only with a battery of the same or equivalent type. Replacement should be done by service personnel only, not general personnel.

• If you are using a power adapter for charging, you should purchase a CCC-certified power adapter that meets the standard requirements.

• Operating frequency: 2402MHz – 2480MHz

• C01 TX Maximum EIRP Power: 5dBm

• C01 RX Maximum EIRP Power: 5dBm

The GODOX C01 KIT2 package contains the following items:

• Transmitter x2

• Receiver x1

• Charging Case x1

• USB-C Charging Cable x1

• Magnet x2

• Instruction Manual x1

• Cartoon Stickers x1

Transmitter Installation:

The transmitter can be clipped directly onto clothing, such as a shirt collar, for easy placement.

Receiver Installation:

Directly connect the receiver to your smartphone’s charging port. You can also charge the smartphone while the receiver is in use by plugging a charging cable into the receiver’s port.

Button Operations:

• Press once (x1): Toggles noise cancellation on/off.

• Press twice (x2): Initiates pairing and acts as a remote control for shooting.

• Press and hold for 2 seconds (2s): Turns the power on or off.

Indicator Light Meanings:

• Flash green slowly: Unpaired

• Flash green quickly: Pairing

• Constant on green: Paired with noise cancellation off

• Constant on orange: Noise cancellation is on

• Constant on red: Low battery level

• Breathe blue: Charging

• Constant on blue: Fully Charged

Button Operations:

• Press once (x1): Toggles noise cancellation on/off.

• Press twice (x2): Initiates pairing.

• Press and hold for 3 seconds (3s): Adjusts the volume. Note: Volume adjustment is only available when the receiver is in a paired status, and it cycles through low, medium, and high levels.

Indicator Light Meanings:

• Flash green slowly: Unpaired

• Flash green quickly: Pairing

• Constant on green: Paired with noise cancellation off

• Constant on orange: Noise cancellation is on

• Constant on red: Low battery level in the corresponding transmitter

• Flash blue once: Volume is set to Level 1 (low)

• Flash blue twice: Volume is set to Level 2 (medium)

• Flash blue three times: Volume is set to Level 3 (high)

The four indicator lights on the charging case represent the battery level as follows:

• One light on: 0-25% battery

• Two lights on: 25%-50% battery

• Three lights on: 50%-75% battery

• Four lights on: 75%-100% battery