PETLIBRO DOCKSTREAM 2 PLWF106 (01) PDF Document

The following items are included with your PETLIBRO DOCKSTREAM 2 PLWF106:

• 1 x Smart Fountain

• 1 x Power Adapter

• 1 x Power Cable

• 1 x Spout

• 1 x Water Pipe

• 1 x Filter & Cleaning Brush

• 1 x User Manual

The main components of the PETLIBRO DOCKSTREAM 2 PLWF106 are:

• Spout

• Filter Cover

• Filter

• Stainless Steel Water Tray

• Filter Tray

• Foam Filter

• Water Pipe

• Water Rotor

• Rotor Cover

• Water Tank

• Fountain Base

Warning: Stainless steel water tray and filter tray are integrated and cannot be detached.

Step 1: Route the power cable through one of the cable slots on the bottom of the fountain to ensure accurate water-level monitoring.

Step 2: Scan the QR code in the user manual or search for “Petlibro” in your smartphone’s app store to download and install the App. NOTE: The Petlibro Lite App is not compatible with this fountain. If you already have the Petlibro App installed, make sure you’re using the latest version.

Step 3: When the Wi-Fi indicator light flashes white, the fountain is ready to connect to the App.

Step 4: Follow the instructions in the App to configure the network.

To calibrate the PETLIBRO DOCKSTREAM 2 PLWF106, place the empty base on a flat surface and follow the calibration instructions within the app.

Step 1: Soak the filter in tap water for 5 minutes and rinse thoroughly, then rinse all tank parts. Do not use water above 50°C / 122°F.

Step 2: Place the water pipe inside the water tank.

Step 3: Attach the soaked filter and install the filter lid. Fill the tank with water, install the water tray, and snap the lid in place.

To reset the Wi-Fi settings, press and hold the Wi-Fi Reset Button for 3 seconds. The fountain will enter network configuration mode.

• Please install and use the fountain strictly in accordance with the instructions provided.

• Use the fountain indoors only. Avoid exposure to high temperatures, high humidity, or direct sunlight.

• The fountain uses a low-voltage 5V power supply. While your pet will not receive an electric shock if they bite the cable, it may cause leakage. Position the cord to discourage chewing.

• Always use the original power adapter provided to avoid damaging the fountain or causing safety hazards.

• Place the fountain on dry, stable, level ground and keep it horizontal and upright. Overturning the fountain may cause malfunctioning or water leakage.

• Before using the fountain for the first time, please clean it thoroughly. Do not use water above 50°C.

• Do not wash or submerge the fountain’s base. If the base gets wet during cleaning, wipe it dry immediately to prevent damage.

• Do not clean any parts of the fountain in a dishwasher.

• Turn off the power when the fountain is not in use.

• If you don’t plan to use the fountain for a long period of time, clean and dry it completely, then store it in a dry place.

• Dispose of packaging materials properly. Plastic bags can lead to suffocation—always keep them away from children and pets.

• Do not use the fountain with pets that can’t reach the water tray or have physical disabilities that prevent them from using it properly.

• Always make sure there is water in the tank before using the fountain. Do not operate the fountain with an empty tank.

• Please perform any repairs under the guidance of professionals to avoid potential accidents and injuries.

• Before leaving home, check that the fountain has enough water and power to operate while you’re out.

• This fountain is not intended to replace human care. For their safety, pets should not be left unattended for extended periods of time.

• For best results, clean the water tank and internal parts every week, and replace the filter every week.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

• This device may not cause harmful interference.

• This device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Innovation, Science and Economic Development Canada Statement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

• This device may not cause interference.

• This device must accept any interference, including interference that may cause undesired operation of the device.

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment complies with FCC’s and IC’s RF radiation exposure limits set forth for an uncontrolled environment. The antenna(s) used for this transmitter must be installed and operated to provide a separation distance of at least 20 cm from all persons and must not be collocated or operated in conjunction with any other antenna or transmitter. Installers must ensure that 20cm separation distance will be maintained between the device (excluding its handset) and users.

The PETLIBRO DOCKSTREAM 2 PLWF106 should only be used with the provided power cable and power adapter. The compatible model lists are: