DELONGHI ICM16710 (01) PDF DOCUMENT

Please observe the following safety warnings when using your DELONGHI ICM16710 coffee maker:

Danger! (Risk of electric shock)

The power cable must not be replaced by the user. If it is damaged, contact De’Longhi Customer Services.

Never immerse the coffee maker in water.

Unplug the appliance when not in use. Do not leave it switched on unnecessarily.

Use with care, especially in the presence of children.

Ensure your mains voltage matches the rating plate on the appliance. Connect only to an efficiently earthed socket with a minimum rating of 10A.

If the plug does not fit the socket, have the socket replaced by a qualified electrician.

Avoid spilling liquid on the plug or power cable.

Danger of burns!

This appliance is designed to “prepare coffee”. Be careful to avoid scalds from spraying water or steam.

Do not touch the hot surfaces. Use the knobs or handles.

Never touch the appliance with wet or damp hands or feet.

The plate remains hot after the appliance has been used.

Important! (Risk of injury or damage)

The manufacturer is not liable for damage caused by inappropriate, incorrect, or irresponsible use.

In case of malfunction, unplug the appliance. For repairs, contact De’Longhi Customer Services only.

This appliance can be used by children aged 8 years and above and persons with reduced capabilities if they have been given supervision or instruction. Keep the appliance and its cord out of reach of children younger than 8 years.

After unpacking, ensure the appliance is complete and undamaged. Keep packing elements like plastic bags away from children.

Place the appliance on a work surface far away from water taps, basins, and sources of heat. Leave a space of at least 5 cm between the sides/rear of the appliance and walls, and at least 20 cm above the coffee maker.

Never install the appliance where the temperature may reach 0°C or lower, as the water freezing could damage it.

This is a household appliance only. It is not intended for use in:

staff kitchen areas in shops, offices and other working environments;

farm houses;

by clients in hotels, motels and other residential type environments;

bed and breakfast type environments.

The parts of the DELONGHI ICM16710 are:

A. Glass jug (certain models only)

B. Thermal jug (certain models only)

C. Measure

D. Water level indicator

E. Lid

F. Water fill compartment

G. Filter holder for drip coffee

H. Permanent filter (if provided) or paper filter

I. Plate (heats up in models with glass jug only)

L. AROMA button

M. On/stand by button

N. Display

O. /AUTO button with light

P. Set timer/clock button

Q. My aroma button

R. Descale button

S. Water tank filter

When turning on the appliance for the first time, the clock will show 12:00. To set the clock:

1. Press and hold the Timer/clock button (P) for more than 2 seconds.

2. A single press of the Timer/clock button (P) increases the time by one-minute increments. Keep pressing to increase the speed.

3. After you stop pressing the button, the clock will be set after 3 seconds, and the appliance will return to active mode.

If the timer is not set, the default is 6:00. To set the timer:

1. Press the Timer/clock button (P). The clock icon will turn on.

2. A single press increases the time by one minute; holding the button increases the time faster.

3. After 3 seconds of no button presses, the timer is set, and the appliance will turn to active mode. The clock icon will turn off.

To activate the AUTO mode for a timed brew, press and hold the /AUTO button (O) for more than 2 seconds. The clock icon will turn on, and the BREW will start at the preset time.

Please note: The first time you use the appliance, wash all accessories and internal circuits by making at least two jugs of coffee without using any ground coffee.

To make coffee:

1. Open the lid (E) and use the jug to pour cold water into the water fill compartment (F) up to the level indicated for the number of cups you want to make. You can check the level via the window (D).

2. Place the permanent filter (H) (if provided) in the filter holder (G). If you don’t have a permanent filter, use a paper filter (size 1×4).

3. Add pre-ground coffee into the filter using the provided measure (C) and level it evenly. Refer to the recommended quantities table. Never exceed 10 measures.

4. For models with a glass jug (A), close the lid (E) and place the closed jug on the plate (I).

5. For models with a thermal jug (B), ensure the jug’s lid is closed before placing it on the base.

6. Press the On/stand by button (M) or the /AUTO button (O) to start brewing. The appliance will beep when delivery begins and three times when it ends.

The quantities are indicative and can be adapted to your personal taste. Use good quality, medium pre-ground coffee. Note: 1 level measure = 1 tablespoon (5 g).

These functions enable a slower percolation process, which improves the flavor and aroma of the coffee.

For models with electronic controls (My aroma button Q):

Press the “my” My aroma button (Q) to cycle between three different strength options:

For models with switch (AROMA button L):

Press the AROMA button (L) to enable the function; the light on the button will turn on. Press it again to disable the function. This is recommended when you are not making a full jug of coffee.

Models with glass jug: If you leave the On/stand by button (M) pressed after brewing, the hot plate will keep the coffee at an ideal temperature. The appliance automatically turns off 40 minutes after brewing ends. To turn the plate off sooner, press the On/stand by button again.

Models with thermal jug: The appliance turns off automatically after brewing has ended. To pour coffee, press the button on the lid. To remove the lid completely, turn it to the “OPEN” position.

For any model, to start a new brewing cycle, switch the appliance off and then on again.

Before cleaning, turn the appliance off, unplug it from the mains, and allow it to cool completely.

Do not use solvents or abrasive detergents. Wipe the coffee maker with a soft, damp cloth.

Never immerse the coffee maker in water.

The water tank filter (S) can be reached through the lid (E) and should be cleaned when necessary.

You are recommended to descale the coffee maker every 40 coffee-making cycles, especially if the water in your area is hard. The appliance will notify you when descaling is needed.

Indication for Descaling:

Models with electronic controls: The Descale button (R) will flash.

Models with switch: The AROMA button (L) and On/stand by button (M) will flash simultaneously.

Descaling Procedure:

1. Use a commercially available descaling product for drip coffee makers.

2. Dilute the descaler in the jug according to the instructions on its packaging.

3. Pour the solution into the water fill compartment.

4. Place the jug on the warming plate.

5. To start the descaling cycle:

For electronic models: Press the Descale button (R) and then press the /AUTO button (O).

For switch models: Press the On/stand by button (M) and AROMA button (L) simultaneously for more than 1.5 seconds. Let it percolate the equivalent of one cup, then turn the appliance off.

6. After the descaling cycle, rinse the appliance by operating it with water only at least 2 times (2 complete tanks of water).

The appliance resets automatically after descaling is complete.

WARNING – THIS APPLIANCE MUST BE EARTHED

The wires in the mains lead are coloured in accordance with the following code:

Green and yellow: Earth

Blue: Neutral

Brown: Live

When connecting to a plug:

The green and yellow wire must be connected to the terminal marked with the letter E, the earth symbol, or coloured green/green and yellow.

The blue wire must be connected to the terminal marked with the letter N or coloured black.

The brown wire must be connected to the terminal marked with the letter L or coloured red.