ASPIRE FEEDLINK REVVO (01) PDF Document

1* Feedlink mod

1* 2ml Revvo Boost tank

2* Coils (0.10-0.14Ω)

1* Glass tube

11* O-rings

2* Warning card

1* User manual

1* Warranty card

Bottom fill (fill through the Squonk pin)

Adjustable airflow

2ml capacity

Innovative ARC (Aspire Radial Coil) technology

Coil resistance 0.1-0.14Ω

Wattage range: 70-80W

Diameter: 24mm

Length: 41mm

To fill the tank, squeeze the e-juice bottle located inside the mod.

Do not let the tank become completely empty. Refill the tank to avoid dry burning or damage to the atomizer.

1. Unscrew and remove the top chamber.

2. Unscrew and remove the mounting screw.

3. Remove the used ARC coil by lifting over the metal pin.

4. Place a new coil over the metal pin, make sure the coil edge is lined up with the tank.

5. Screw the mounting screw back onto the base hardware.

6. Replace the top chamber.

NB: The mounting screw also acts as a ‘spit-back’ guard.

1. Unscrew and remove the glass securing ring from the base hardware.

2. Pull and remove the used glass tube.

3. Insert a new glass tube.

4. Screw the glass securing ring back onto the base hardware.

Output voltage: 3.0-4.2V

Resistance parameter: 0.1-3.5ohm

Modes: Bypass output

Non-adjustable Wattage/ Voltage

Battery type: Single 18650 high rate discharge battery (discharge rate ≥35A)

Continuous firing time: 10 seconds

Silicone bottle capacity: 7ml

Automatic cutoff: The continuous fire time is 10 seconds, after 10 seconds of continuous firing the mod will stop firing and the LED light under the fire button will flash 10 times.

Battery reverse protection.

Short circuit protection: When the mod detects a short, the LED light will flash 2 or 3 times.

Over discharge protection: When the battery level is below 3.2V, pressing the fire button the orange light will flash 15 times.

Over heat protection: When the temperature of the control board is above 75 degree Celsius, the mod will shut off and the LED light will light up blue and orange for 3 seconds.

Installing an 18650 battery into the mod: The LED light will flash blue and orange 2 times.

When the battery level is above 3.8V: The LED light will be blue only.

When the battery level is between 3.5V and 3.8V: The light will be a mixed color of blue and orange.

When the battery level is below 3.5V: The orange light means the battery level is below 3.5V.

Click the fire button 5 times rapidly to lock or unlock the device. The LED light will flash blue and orange 3 times to indicate lock or unlock. When the mod is unlocked, pressing the fire button will cause the blue or orange LED light to light up according to the battery level.

1. Lightly push in the bottle securing cap at the bottom of the mod.

2. Then twist counter-clockwise direction to remove the securing cap.

3. Insert a new silicone e-juice bottle into the plastic carrier frame, reinsert the frame into the mod then push the knob and twist clockwise direction to secure.

1. Unscrew and remove the metal cap at the top of the bottle.

2. Add your preferred e-juice into the bottle.

3. Replace metal cap.

1. Invert the Feedlink mod and unscrew the battery cap.

2. Insert an 18650 battery into the battery compartment with positive end pointing down and negative end pointing up.

3. Screw the battery cap back onto the mod.

Nicotine containing e-liquids are not recommended for:

Non-smokers

Young people under the age of 18 years

Pregnant or breast feeding women; as nicotine is known to cross the placenta and to be excreted in breast milk

Those experiencing general ill health; such as heart disease, stomach and duodenal ulcers, liver or kidney problems, long term throat disease or difficulty breathing due to bronchitis, emphysema or asthma

Those who have an overactive thyroid gland or have a phaeochromocytoma (a tumour of the adrenal gland that can affect high blood pressure)

Those who have diabetes, as nicotine may affect your blood sugar levels

Those taking the following medication: Theophylline (to treat breathing problems), Ropinirole (to treat restless leg syndrome), Clozapine (to treat schizophrenia)

If you inhale too much nicotine or use the product too much you may experience one or more of the following effects:

Feeling faint

Nausea (feeling sick)

Headache

Coughing

Irritation of the mouth or throat

Dizziness

Stomach discomfort

Hiccups

Nasal congestion

Vomiting (being sick)

Heart palpitations

Abnormal heart rate

If you experience any of these side effects; including any possible side effects not listed in the leaflet, discontinue using the product, if the effect(s) continue after you stop use, consult your doctor or healthcare professional.