Free English V-TAC VT-1055-1 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD V-TAC VT-1055-1 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
What are the technical specifications for the V-TAC VT-1055-1 LED Flood Light?
| MODEL | VT-1055-1 |
| SKU | 23697, 23870 |
| POWER | 1000W |
| BEAM ANGLE | 60° |
| LUMENS @SPHERE360° | 160000Lm |
| INPUT VOLTAGE | AC: 220-240V, 50Hz |
| DF | >0.9 |
| CRI | >70 |
| LIFE SPAN | 25,000 Hours |
| ON/OFF CYCLE | >15,000 Times |
| OPERATION TEMPERATURE | -20°C to +45°C |
| BODY TYPE | Diecast Aluminium |
| DIMENSION | 676x74x840mm |
What are the key warnings and safety precautions for installing the V-TAC VT-1055-1?
1. Please make sure to turn off the power before starting the installation.
2. Installation must be performed by a qualified electrician.
3. The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.
4. The external flexible cable or cord of this luminaire cannot be replaced; if the cord is damaged, the luminaire shall be destroyed. It shall be exclusively replaced by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
5. Replace any cracked protective shield.
6. Terminal block not included.
7. Proper grounding should be ensured throughout the installation.
8. Minimum distance from lighted objects 1m.
9. For outdoor use.
The light source is a replaceable (LED Only) type to be handled by a professional.
What are the specific installation notes for the V-TAC VT-1055-1?
• To reduce the risk of strangulation the flexible wiring connected to this luminaire shall be effectively fixed to the wall if the wiring is within arm’s reach.
• In order to maintain the IP protection of the product, the cable entry/gland should be installed on the bottom side.
What are the step-by-step installation instructions for the V-TAC VT-1055-1?
1. Turn off the power.
2. Loosen the screws to remove the bracket.
3. Determine the installation location.
4. Drill holes into the building surfaces.
5. Insert wall plugs into the drilled holes.
6. Secure the bracket to the wall by tightening the screws.
7. Install the lamp body onto the bracket and lock it in place by tightening the bracket screws.
8. Adjust the angle of the lamp (adjustable from 0° to 180°). Once positioned, tighten the angle adjustment screw and the bracket fixing bolt.
9. Connect the electrical wires:
• Brown wire to the «L» (live) wire
• Blue wire to the «N» (neutral) wire
• Yellow-green wire to the ground wire
Use insulation tape and waterproof tape for insulation and waterproofing. It is recommended to use a professional waterproof junction box.
10. Turn on the power and test the light.
What does the crossed-out wheeled bin symbol on the V-TAC VT-1055-1 mean?
What does the lightning bolt symbol on the V-TAC VT-1055-1 signify?
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
CLICK HERE TO DOWNLOAD V-TAC VT-1055-1 (01) PDF DOCUMENT