SHARPER IMAGE 212219 (01) PDF Document

STEP 1: DOWNLOAD THE APP

• iPhone Users: Search the iTunes App Store for the free “iSearching” app and download it.

• Galaxy/Android Users: Search Google Play for the free “iSearching” app and download it. Or, you can scan the QR Codes in the user guide to download the apps instantly.

Remember to allow notifications from the app. For more help, tap the Description icon in the app.

STEP 2: TURN ON BLUETOOTH

• Turn Bluetooth on for your device.

• Go to “Settings” then “Bluetooth” on your phone and make sure that Bluetooth is ON or Enabled.

1. Open the iSearching app and tap the plus button in the top right corner.

2. Remove the plastic battery pull tab. Press and hold the function button on the Item Locator for 3 seconds.

3. The locator will beep twice and a blue light will flash. It is now entering pairing mode.

4. The Lost Item Locator will appear in the device list as iTAG.

5. Tap “Unconnected” to connect the device.

NOTE: If the Lost Item Locator is not pairing, make sure the device is disconnected from all other phones.

• Tap the Setting icon and input a new name for your Lost Item Locator.

• In Settings, tap Device Picture to add a picture of the item associated with the locator.

1. Launch the app on your mobile device.

2. Select your desired Lost Item Locator from the “Devices” list.

3. Tap Click Alarm to make the alarm sound on the Lost Item Locator. (To stop the alarm, tap Stop Alarm in the app.)

When your Locator is connected and within range, you may use it to find your misplaced phone. Press the function button twice in succession to trigger an alert on your phone. Tap OK on your phone to stop the alert.

The SHARPER IMAGE 212219 has a Bluetooth connection range of approximately 75 feet with no barriers. If the locator and your phone are out of range, both devices will make an alert sound. To use this feature, activate the button “Alarm When Bluetooth Disconnected” in the locator Settings.

NOTE: This will only work if the locator and the phone are turned on and paired.

1. Open the app and tap the camera icon.

2. Click the function button on the Lost Item Locator to take a picture.

3. Tap the camera icon again to exit camera mode.

Please make sure your device supports Bluetooth 5.2. The locator is compatible with Apple devices running iOS 8.0 or later and compatible with Android 4.4 or later.

Press and hold the locator’s function button for at least 3 seconds to turn power off. A long single beep indicates the device is turned off.

In the Device list, slide to the left to delete a locator.

When parking, simply press the locator’s function button to mark your current location on the map. To locate your vehicle, tap “Location” in the app.

The battery type is CR2032. To replace the battery, insert a small flat screwdriver into the small slot found along the seam of the locator and gently turn to open the locator.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio / TV technician for help.

Important: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.