IMAGE A7 (02) PDF Document

1. iMage A7 Bluetooth Lavalier Micorphone x1

2. Micro USB cable x1

3. Operation manual x1

1. Power/charging status light indicator

2. Microphone jack

3. Microphone mute/unmute

4. USB port

5. Power button/Fn button

6. Playback volume down

7. Playback volume up

8. 3.5mm Phone Jack

Please charge your iMage A7 by connecting it to a USB port. Please fully charge your product before using it for the first time.

Ready Mode: Once powered on and the power status light indicator turns white, then the device is in ready mode.

Charging: Once the iMage A7 is powered off and the power status indicator (NO.1) is turned on, then the device is charging; it turns off once the device is fully charged.

Battery Level: When the power status indicator (NO.1) flashes red, the battery is low and charging is required. It turns off when the battery is full.

Note: A battery left uncharged for a long time may hamper its service life significantly. Please recharge your device at least once a month.

Press and hold the power button for 4 seconds to power on your iMage A7; it then enters different modes based on sources of sounds detected.

Optional host devices, including iMageTech M6 Wireless Speakerphone System, iMage VC Adapter II, and iMage Dongle are required to cascade connecting to the audio I/O of the video device to enable the iMage A7 as an external auxiliary microphone of your video system.

Connection method:

1. Turn on the iMage A7 to enter the pairing ready mode.

2. Connect the I/O port of iMageTech M6 or iMage VC Adapter II to the audio I/O port of the video device. If an iMage Dongle is available, connect it to the USB port of your computer for auto connection with iMage A7.

3. Power on iMageTech M6 or iMage VC Adapter II to auto-connect to iMage A7; once connected, proceed with the meeting by using the latter to talk with the attendants and listen to remote ones through the 3.5 phone jack.

* Please refer to manuals of host devices including iMageTech M6 Wireless Speakerphone System/iMage VC Adapter II/ iMage Dongle for detailed connection steps.

* In case of any connection error between the A7 and the host device, try re-connecting the two by pressing the pairing button of the host device or running the iMageTech Audio Management App.

You can connect smartphones, tablets, and other mobile devices to make the iMage A7 an external microphone.

Connection method:

1. Power on your iMage A7 to enter the pairing ready mode.

2. Select “Search Bluetooth device” on the smartphone or tablet device you want to connect to.

3. Click to select “iMage A7_XX” on the device list to pair with it.

4. Once the white mode light indicator is on: the smartphone or tablet device is now paired with iMage A7 with support for HFP and A2DP.

* Note: These figures are measurements made in a lab environment; actual data may vary with operating scenario.

You may Bluetooth connect your iMage A7 product to a smartphone or tablet. You need an optional iMage Dongle to connect with a computer or notebook for wireless operations.

Bluetooth is a wireless technology very sensitive to obstacles found in between connected devices. The maximum transmission range of Bluetooth is 15m, in case there are no large obstacles (e.g., walls) found in between the connected devices. When used with iMage M6 and the connection channel is fully loaded, the transmission distance can reach up to 10 meters.

You may have removed the pairing data during operation; please refer to steps given in the “Bluetooth mode” section.