PYLE PPHP2894B (01) PDF Document

If your PYLE PPHP2894B causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, you are encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

NOTE: This device and its antenna(s) must not be co-located or in operation in conjunction with any other antenna or transmitter.

To maintain compliance with FCC’s RF Exposure guidelines, this equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body. This device and its antenna(s) must not be co-located or operate in conjunction with any other antenna or transmitter.

Be aware that the electric power supply line is not tramped or pressed by heavy objects. Pay special attention to the plug of the power supply line and the outlet on the machine. DO NOT lengthen the electric shock cord, and DO NOT pull or drag the power supply line.

This set must be put in a ventilated place. DO NOT put a disk on it or cloth to cover it. The distance away from the wall should not be less than 10 centimeters. DO NOT put this set on the bed, sofa, carpet, or other objects with a similar surface in case of poor ventilation.

DO NOT dismantle the casing. If one touches the inner components, they will probably get a serious electric shock.

When you discover an unusual smell and smoke, cut power supplies immediately and pull the plug from the outlet on the wall. Contact the sell shop or nearest repairing center.

1. Power: Standby button.

2. MODE: Used to switch the BT, FM, AUX, USB, SD.

3. MUTE: Mute button.

4. REC: Recording, press once to start recording, press again to play the current recording.

5. VOL +: Main volume increase.

6. ►►I: Next song/Next channel.

7. I◄◄: Previous song/Previous channel.

8. ►II: Play/Stop. Auto-search by pressing and holding the FM button. Press and hold the BT button to turn on TWS.

9. VOL -: Main volume decrease.

10. REPEAT: Single repeat/repeat all.

11. EQ: Choose from EQ1, EQ2, EQ3, EQ4…

12. Number Pad (0-9): Choose song number directly/channel directly.

1. POWER ON/OFF: Turns the unit on and off.

2. USB port: For USB flash drive input.

3. Micro SD port: For Micro SD card input.

4. CHARGE: Charge indicator light.

5. DC 9V IN: DC 9V charging port.

6. AUX: AUX input.

7. MIC 1: Mic 1 input.

8. MIC 2: Mic 2 input.

9. LED. SW: Turns the LED lights ON/OFF.

10. MODE: Mode Switch for BT, FM, AUX, USB, MicroSD.

11. MENU: Menu key to enter treble, bass, microphone volume/ECHO adjustment increase and decrease.

12. MIC. PRIORITY: Activates microphone priority.

13. K◄◄ CH-: Previous song channel.

14. ►II SCAN: Play/stop. Press and hold to auto-search FM channel. Press and hold in BT mode to turn on TWS.

15. ►►I CH+: Next song next channel.

16. VOL: Main volume knob.

1. Ensure the Portable PA Speaker is turned off. Ensure all volume controls are turned all the way down. Next, connect one side of the included power cable to the Portable PA Speaker’s power inlet and the other to a grounded power outlet.

2. Ensure that the power supply complies with the power requirements listed on the identification sticker located on the bottom of your product. Turn on the power to the Portable PA Speaker using the power switch.

3. Slowly turn up the function keys until the desired level is reached.

Switch the Portable PA Speaker to MODE, then switch to BT (BT MODE) pairing mode and connect to a new BT device using BT Network Name: ‘PYLE USA’.

Keep the unit out of direct sunlight and away from heat sources. Place the unit in an upright position during use and storage. Keep the unit away from moisture or dusty environments.

Use a soft cloth with a neutral detergent to clean the cabinet, panel and controls. To avoid damage, do not use solvents to clean this equipment.

Warning: To prevent the risk of fire or electric shock, do not expose this appliance to rain or moisture. To prevent electric shock do not remove the cover. No user serviceable parts inside. Refer servicing to qualified service personnel.

Safety: Prior to connecting mains, ensure that the supply voltage is correct and the mains lead is in good condition. Avoid ingress of water or particles into the enclosure.