PYLE PDIC1661RD (01) PDF Document

Follow these steps to install your PYLE PDIC1661RD speakers:

Step 1. Cut the drywall. Note: Always allow at least one-half inch between a wall stud and the speaker cutout or the locking tabs will not be able to swivel into place.

Step 2. Connect the speaker wires to the speaker.

Step 3. Screw down each of the four Phillips head screws. The locking tabs will swivel into place and secure the unit to the rear surface of the drywall. Put in the strips of adhesive to secure the grille.

Step 4. Replace the metal grille to complete the installation.

Specifications:

In-Wall/In-Ceiling System

2-Way Stereo Sound Speakers

Includes (2) 6.5-inch Speakers

1/2″ High Compliance Polymer Tweeter

Polypropylene Cone with Rubber Edge

Mounts Flush on Walls or Ceilings

Environmentally Friendly ABS Construction

Perfect for Custom Installations & Applications

Includes Round Stain Resistant Grills

Cut-Out Template for Easy Installation

Technical Specs:

200 Watt Rated Peak Power

Frequency Response: 70Hz-20kHz

Impedance: 16 Ohms

Sensitivity: 88 dB

Total Unit Dimensions (Diameter x Depth): 9.0″ x 3.1″

Cutout Diameter: 7.6″

Cutout Mounting Depth: 2.8″

The volume control is designed to be mounted in a standard electrical wall box. Select a location that is within reach of the speaker wires and easy to reach for using the volume control.

Warning: You must mount the volume control in a standard electrical box; do not mount it directly on a wall.

Note: The depth of the unit is 2 5/8 inches.

Caution: The volume control is limited to a maximum of 50 watts RMS / 100 watts maximum per channel.

1.) Run 4-Conductor speaker cable from the amplifier (positive and negative for both the left and right channel) to the volume control. Similarly, run 2-conductor speaker cable from each of the speakers to the volume control. Label the cables for future reference.

2.) Measure the depth of the volume control to make sure it will fit in the j-box.

3.) Connect the speaker cable to the volume control:

a. Strip ½” of insulation from the end of each cable.

b. Tightly twist the wires in each cable until there are no frayed ends.

c. Insert the 4-conductor speaker cable from the amplifier into the input terminals.

d. Insert the two 2-conductor speaker cables from the speakers into the output terminals.

4.) Connect additional speakers in parallel.

5.) Make sure that all connections between your amplifier and the volume control, and between the volume control and each speaker, are in “phase”, that is (+) to (+) and (-) to (-).

6.) Turn the volume knob to the “off” position (all the way down.)

7.) Screw J-box into place.

8.) Put on faceplate and screw in place using the screws.

10 volume positions

Control volume from any room

Works with all audio & video systems

Standard & Decora wallplates included

Mounts in-wall

Frequency Response: 20 Hz-20 kHz

Power Handling: 50 watts RMS / 100 watts maximum per channel

Attenuation:

1st position (slider at bottom): Full off

2nd and 3rd position: attenuate 6 +/- 1 dB per step

4th through 9th position: attenuate 3 +/- 1 dB per step

10th position: Full on

Insulation Resistance: 100 megaohm @ 500 V D.C.

Dielectric Withstanding Voltage: 500 V AC, 1 minute

Weight: 7.8 oz.

Depth: 2 5/8″.