PETLIBRO CAPSULE PLWF002 (01) PDF Document

Please adhere to the following safety warnings when using your PETLIBRO CAPSULE PLWF002:

• Dispose of all packaging materials properly. Keep the polybags away from children and pets as these bags could cause suffocation.

• Do NOT allow children to play with, in or around the pet water fountain.

• To avoid injury, please keep close supervision when the appliance is used near children.

• Do NOT use the water fountain with pets not able to reach the water tray or with any physical disability.

• Do NOT place any foreign object in the water tank.

• Do NOT disassemble the pet fountain other than components as instructed in this User Manual.

• Do NOT use the pet fountain for anything other than its intended use.

• Only use attachments recommended or sold by the manufacturer. The use of attachments not recommended or sold by the manufacturer may cause an unsafe condition. Do NOT modify the pet fountain.

• Do NOT operate any appliance if the unit is malfunctioning or has been damaged. Do not attempt repairs on the device yourself.

• Be sure to disconnect the power supply for safety when the appliance is not in use.

• Please disconnect the power supply before maintaining and cleaning the machine.

• Always unplug the appliance when not in use; or before putting on or taking off parts and before cleaning.

• The power adapter and wire plug must not be flooded during cleaning.

• This product is for indoor use only.

• This product is not allowed to run without water.

• Never pull the electrical power cord to remove the plug from the wall outlet.

• If the plug of this device gets wet, turn off the electricity of that wall outlet. Do NOT attempt to unplug.

• Check the device after installation. Do NOT plug in if there is water on the contact points or plug.

• To avoid tripping, always position the power cord out of the way of foot traffic.

• Do not use the appliance in the bathroom.

• Change the filter every 2 weeks or when the flow rate has noticeably reduced. For two or more cats, you may need to replace the filters more regularly if it becomes blocked.

• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

• The appliance is only to be used with the power supply unit provided with the appliance.

• If the cord set is damaged, it must be replaced by a special cord set available from the manufacturer or its service agent.

• Do NOT allow pets to chew on or swallow any parts. If you are concerned about the power cord, purchase a cord conduit (a hard-plastic protector) at any hardware store to protect the power cord.

• If an extension cord is necessary, one unit with a proper rating should be used.

• Do NOT install or store the pet water fountain where it will be exposed to weather or temperatures below 0°C / 40°F.

• Read and observe all important notices listed on the pet water fountain and in the packaging.

The PETLIBRO CAPSULE PLWF002 consists of the following parts:

1. Spout

2. Water Outlet

3. Water Tray

4. Filter

5. Filter Tray

6. Water Pipe

7. Water pump with power cord

8. Foam Filter

9. Charger

10. Soft Plug

11. Cord Slot

12. Water Tank

1. Soak the filter in a clean bowl for 5 minutes, then rinse the filter thoroughly with tap water.

Notes: The filter must be fully soaked before the fountain is turned on; otherwise, water may not flow through the filter smoothly and cause spillage. Do not soak the filter in the water tank of the fountain in case of any surface dust.

2. Position the pump according to the bottom slot shape. Press the pump to make the suction cups under the pump stick tightly. Put the cord in the slot. The pump must be fixed in the right position in the tank.

3. Install the soft plug. To prevent water leakage and secure the power cord in the cord slot, please align the cord slot when installing the soft plug.

4. Install the silicone pipe on the pump. Add water to the tank. Keep the water level between the Min and Max level. The pump will fail if it runs dry.

5. Install the filter tray and place the filter on the filter tray. Press down firmly to make sure the pipe outlet comes out.

6. Install the water tray. Whether to install the spout depends on your pet’s drinking preference.

7. Connect the power adapter.

1. Clean the water tank, tray and foam filter at least once a week.

2. Clean the pump and replace the filter at least once every 2 weeks.

3. To extend the life of pump, please add water before starting the machine.

1. Remove the pump cover and impeller cover in sequence. Note: The foam filter is in the pump cover, change the foam every 2 weeks.

2. Remove the impeller with the brush hook.

3. Use the brush to clean the parts with water.

Tip: The brush can also be used to clean the spout. It is recommended to clean the spout every 2 weeks.

The filter may not be fully soaked. Please soak the filter in a clean bowl (not in the water tank) for 5 minutes before the first use.

1. Fill in water between MIN and MAX. The pump will fail if it runs dry.

2. Clean the pump, water tank, and drinking basin.

3. If the above solutions don’t work, further assistance may be required.

It’s recommended to replace the filters every 2 weeks.

The filters absorb more water (and therefore clean more water) when they’re wet and expanded. Soaking the filter removes particulate matter that may have settled on the filter.

For the first use (or reuse after long-time storage), the water pump needs to discharge air. It’s normal if the water output speed is slow initially.