PETLIBRO DOCKSTREAM PLWF105 (01) PDF Document

The following items are included with your PETLIBRO DOCKSTREAM PLWF105:

• 1 x Automatic Pet Water Fountain

• 1 x Power Adapter

• 1 x Power Cable

• 1 x User Manual

The PETLIBRO DOCKSTREAM PLWF105 consists of the following parts:

1. Spout

2. Filter Lid

3. Filter

4. Stainless Steel Water Tray

5. Filter Tray

6. Water Pipe

7. Foam Filter

8. Wireless Water Pump

9. Snap Lids

10. Water Tank

11. Power Cable

12. Power Adapter

13. Tank Base

14. Load Cell Sensor

To install your PETLIBRO DOCKSTREAM PLWF105, please follow these steps:

1. Soak the filter in a clean bowl of water for five minutes, then rinse the filter thoroughly with tap water.

2. Install the water fountain components and the filter.

Power on:

Connect the fountain to a wall outlet with the power adapter and power cable. Please route the cable through one of the cable slots on the bottom of the fountain for accurate water level monitoring.

Power off:

Unplug the cable from the outlet.

1. Download and install the PETLIBRO app.

2. Follow the in-app instructions to configure the network and connect your device.

After the fountain is connected to Wi-Fi, press and hold the reset button for six seconds to reset the Wi-Fi settings. The fountain will then enter network configuration mode.

• Use the fountain in a dry place.

• Use the fountain on a level surface.

• Dispose of all packaging materials properly. Some items may be packed in plastic bags; these bags could cause suffocation. Keep them away from children and pets.

• Do not use the water fountain with pets that are not able to reach the water tray or with any physical disability.

• Do not immerse the base part in water at any time as it may damage electronic components.

• Do not use the fountain outdoors. Check its operation frequently to be sure it is operating properly.

• Do not disassemble the fountain other than as instructed in this user manual.

• Only use accessories recommended or sold by the manufacturer. The use of accessories not recommended or sold by the manufacturer may cause an unsafe condition.

• Do not modify the fountain.

• Examine the fountain after installation. Do not plug in if there is water on the power cable or plug.

• To avoid tripping, always position the power cable out of the way of foot traffic.

• Do not install or store the fountain where it will be exposed to weather or temperatures below 0°C (32°F).

• Do not use the fountain without adding water first.

• Power off the device when it’s not in use.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and.

(2) This device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device and its antenna(s) must not be co-located or operated in conjunction with any other antenna or transmitter.