MOUNT-IT MI-2352T (01) PDF DOCUMENT

The MOUNT-IT MI-2352T is designed for laptops with screen sizes ranging from 10 inches to 15.6 inches. It has a rated weight capacity of 4.5kg (9.9lbs).

Before you start installation and assembly, read the entire instruction manual. You must also ensure that you have received all parts according to the component checklist. If any parts are missing or faulty, you should contact your local distributor for a replacement.

Please adhere to the following safety precautions:

CAUTION: Use with products heavier than the rated weights indicated may result in instability causing possible injury.

• Mounts must be attached as specified in assembly instructions. Improper installation may result in damage or serious personal injury.

• Safety gear and proper tools must be used. This product should only be installed by professionals.

• Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.

• Use the mounting screws provided and DO NOT OVER TIGHTEN mounting screws.

• This product contains small items that could be a choking hazard if swallowed. Keep these items away from children.

• This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.

Follow these steps to assemble your MOUNT-IT MI-2352T:

1. Attach the adhesive pads (C) to the inner surface of the two side arms (B). Slide the completed side arms onto the main laptop tray (A).

2. From the back of the laptop tray, use the four provided screws (D) to secure the side arms in place.

3. Attach the assembled laptop holder to your existing monitor mount’s VESA plate (monitor mount not included).

4. Adjust the width of the side arms to custom fit your laptop, then place the laptop onto the holder.

You should perform maintenance by checking that the bracket is secure and safe to use at regular intervals, at least every three months.