Free English JBL NORTHRIDGE FSN26 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD JBL NORTHRIDGE FSN26 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
What is included with the JBL NORTHRIDGE FSN26 speaker stands?
The following items are included:
Two floor-stand posts, with “knurled” nuts, cone-shaped fittings, and 19mm-long hex head bolts installed.
Two weighted bases.
How do I assemble the JBL NORTHRIDGE FSN26 speaker stands?
1. Unscrew the bolt from the bottom of the post.
2. Insert the post into the hole at the rear of the base.
3. Orient the post so that the openings near the top and bottom of the post face toward the rear of the base, making sure that the alignment fin on the shaft fits into its corresponding recess in the back of the hole on the base.
4. Slip the bolt up through the hole in the bottom of the base and into the threaded hole in the bottom of the post.
5. Check the alignment of the post and base; tighten firmly using a 3/4-inch socket wrench.
How do I route the speaker wire through the JBL NORTHRIDGE FSN26 stands?
“Fish” the speaker wire through the stand posts and bring it out through the round hole on the cone-shaped fitting.
How do I attach my speaker to the JBL NORTHRIDGE FSN26 stand?
1. While looking at the top of the stand, turn the “knurled” nut (a) that is installed on top of the threaded shaft (b), by hand clockwise, until it is seated against the top of the stand post (c).
2. Place the speaker on top of the stand, with its stand-attachment hole on the bottom aligned with the stand’s threaded shaft (b). Be careful when starting the threads to avoid cross-threading (misaligning the threads); cross-threading may damage the speaker and/or the stand.
3. Once the threads are properly aligned and engaged (if the threads are not properly engaged, the speaker will not easily rotate on the shaft), turn the speaker clockwise (while looking at the top of the speaker) 8 to 10 turns. The speaker should by then be securely attached to the stand post. Make sure that the speaker grille is facing forward.
4. Using a suitable wrench (not included), securely tighten the “knurled” nut (a) up against the bottom of the speaker until the floorstand post and the speaker are fully locked together, so that neither can be rotated by hand.
5. Pull the cone-shaped fitting (d) up against the speaker bottom, with its speaker wire hole (e) toward the back.
6. Connect the speaker wires to the speaker as outlined in the speaker’s owner’s manual.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
CLICK HERE TO DOWNLOAD JBL NORTHRIDGE FSN26 (01) PDF DOCUMENT