JATA V142 (01) PDF Document

The technical details for the JATA V142 are listed below:

The JATA V142 consists of the following primary parts:

1. Plates.

2. Thermostat knob.

3. Indicator light.

Follow these steps to use the JATA V142:

Step 1. Place the appliance on a flat and heat resistance surface.

Step 2. Plug the unit into the mains and turn the thermostat knob to its maximum position (number 5). The indicator light will turn on and the plate will begin to heat up.

Step 3. It is recommended to initially set the thermostat knob to the highest position (number 5) so the plate reaches a good temperature as soon as possible.

Step 4. Once the desired temperature or boiling point is reached, turn the thermostat knob anticlockwise until the indicator light turns off. The thermostat will then maintain the selected temperature.

Step 5. Note that the plate remains hot for some time after being switched off. You can turn off the cooker shortly before finishing cooking to save energy.

Step 6. When cooking is finished, turn the thermostat knob to the 0 position and unplug the appliance from the mains.

To keep your JATA V142 in good condition, follow these maintenance instructions:

Step 1. Before cleaning, unplug the appliance from the mains and wait until the plate is completely cold.

Step 2. You can clean the body of the appliance with a slightly dampened cloth.

Step 3. To clean the plate, use a slightly dampened cloth with soap. You may also use specialized products designed for cleaning vitroceramic plates.

Step 4. For hard residues, use a scraper suitable for vitroceramic hobs.

Step 5. Do not use abrasive or chemical products, or metallic scourers, as these may deteriorate the surfaces.

Ensure safety while using the JATA V142 by following these rules:

Keep all plastic bags and packaging components out of the reach of children as they are potentially dangerous.

Do not connect the unit to the mains without verifying that the voltage on the rating plate matches your household voltage.

Ensure the plug has an adequate earth base.

Do not leave the appliance unattended while in use or during functioning.

Keep the cable cord away from any hot parts of the cooker.

Always place the cooker on a heat-resistant surface and keep it away from curtains or other flammable materials.

Avoid leaving the appliance functioning with an empty recipient.

Never use the plates as a grill or without a recipient placed on them.

Use recipients with a flat base and a diameter that is the same as or slightly larger than the diameter of the plates.

Do not place metallic objects such as knives, forks, and spoons over the plates.

Do not immerse the main body or the cable cord of the appliance in water or any other liquid.

When unplugging the unit, always pull from the plug and never from the cable.

The JATA V142 is not intended for use with an external timer or a separate remote control system.

If the plate of the JATA V142 is broken, switch off and disconnect the appliance immediately to avoid the risk of a short-circuit or electric shock.

Yes, it is absolutely normal for the JATA V142 to produce some smoke during the first few times it is used. This is due to the protective coatings used during the manufacturing process of the product.

You must avoid moving or changing the location of the JATA V142 while it is working. If you need to move it, first switch it off, unplug it from the mains, and remove any recipients from the plates.

The JATA V142 can be used by children aged 8 or older if they have been given proper supervision or instruction concerning safe use and understand the involved dangers. Cleaning and maintenance by users should not be done by children unless they are over 8 years old and under supervision. Keep the appliance and its cable cord out of the reach of children younger than 8 years old.

If the cable of the JATA V142 were to deteriorate, it must be changed by an Authorised Service Centre.