JATA JVVM3026 (01) PDF Document

The technical data for the JATA JVVM3026 is as follows:

The main components include:

1. Blades.

2. Speed selector.

3. Base.

4. Rear grid.

5. Frontal grid.

6. Head.

7. Nut to fix the grid.

8. Nut to fix the propeller.

9. Oscillation knob.

Carefully read these instructions before using the fan for the first time and keep them for future enquiries.

This appliance can be used by children at the age of 8 or more and people with physical, sensory or mental capabilities or lack of experience and knowledge if they have been given an appropriate supervision or instruction concerning the safety use of the appliances and understand the dangers involved.

Keep all plastic bags and packaging components out of the reach of children. They are potentially dangerous.

Do not connect the appliance to the mains without checking that the voltage on the rating plate and that of your household are the same.

VERY IMPORTANT: Do not immerse the fan in water or any other liquid.

This appliance has been designed for domestic only. Don’t allow children play with the appliance. Keep the fan out of the reach of children.

Make sure neither the appliance nor the cable are in direct contact with hot surfaces or objects.

Always place it on a flat and stable surface.

Do not use outdoors.

Do not use it without the frontal grid correctly assembled.

Do not put the fingers or other objects into the fan to prevent the engine block.

If the power cord is damaged, it must be replaced by the manufacturer or by its after-sales service or similar qualified personnel in order to avoid a danger.

Unscrew the nut to fix the propeller (8) clockwise and the nut to fix the grid (7) anticlockwise.

Place the rear grid (4) into the motor shaft and fix it with the screw grid by turning it clockwise.

Place the blade (1) into the shaft by pressing till the end and screw the nut to fix the propeller (8) into the shaft anticlockwise.

Insert the frontal grid (5) and be sure all the guard clips are closed and the lower part is screwed with the screw.

Remember the fan always must be placed on a flat and stable surface.

Plug the appliance into the mains.

Move the air flow by turning the head in the desired position, check that the oscillating knob (9) is up before doing this operation.

Push the oscillation knob to active the oscillation function.

Raise the oscillation knob (9) to stop this function.

Turn the speed selector (2) clockwise or anticlockwise, making coincide the desired speed position with mark (▲):

– Position 0 – Off.

– Position 1 – Minimum speed.

– Position 2 – Average speed.

– Position 3 – Maximum speed.

Before you proceed to cleaning, make sure the appliance is unplugged from the mains.

Clean with a slightly damp cloth.

It is important to keep the frontal grid (5) and the back grid (4) clean of dust.

You can disassemble the blades for cleaning by following the assembling reverse process.

Do not use abrasive or chemical products, such as metallic scourers, which may deteriorate the surfaces of the appliance.

Dispose the appliance according to the local garbage regulations.

Never throw it away to the rubbish. So, you will help to the improvement of the environment.