DJI OSMO MOBILE 7 (02) PDF Document

The main components of the DJI OSMO MOBILE 7 are:

1. DJI OM Magnetic Phone Clamp 4

2. Pan Motor

3. Status Panel

4. Zoom Slider

5. Joystick

6. 1/4″-20 UNC Port

7. Switch Button

8. Shutter/Record Button

9. Power/M Button

10. Tilt Motor

11. Roll Motor

12. Trigger

13. Charging Port (USB-C)

14. Built-in Tripod

To prepare your smartphone for use with the DJI OSMO MOBILE 7, follow these steps:

1. Download and install the DJI Mimo App on your smartphone.

2. Attach the DJI OM Magnetic Phone Clamp to your phone. Ensure the clamp is positioned in the center of the phone for proper balance.

To power on and unfold the DJI OSMO MOBILE 7, follow these steps:

1. Rotate the top portion of the handle to turn the device on.

2. Unfold the gimbal arm.

3. Extend the legs of the built-in tripod located at the base of the handle.

Follow these steps to connect your smartphone to the DJI OSMO MOBILE 7:

1. After attaching the magnetic phone clamp to your phone, magnetically attach the phone to the gimbal.

2. Open the DJI Mimo App on your smartphone.

3. In the app, a prompt will appear to connect to a device. Select the device named “OM7-xxxxxx” to establish a Bluetooth connection.

To properly power off and store the DJI OSMO MOBILE 7:

1. Press and hold the Power/M button for two seconds until the device powers off.

2. Detach the magnetic phone clamp from the gimbal.

3. Fold the gimbal arm back into its storage position.

4. Retract the built-in tripod legs into the handle.

5. Collapse the handle to its most compact form.

To charge the DJI OSMO MOBILE 7, connect a USB-C cable to the charging port on the side of the gimbal handle. Connect the other end of the cable to a power source, such as a power adapter.