DJI FLYCART 100 (01) PDF DOCUMENT

The remote controller for the DJI FLYCART 100 cannot be powered on before its internal battery is activated. You must activate the internal battery by charging it first.

To install the parachute on the DJI FLYCART 100, align the parachute unit with the mounting bracket on the aircraft and slide it into place until it clicks securely.

To install a payload on the DJI FLYCART 100, follow these steps:

1. Align the payload with the mounting points underneath the aircraft body.

2. Push the two locking levers on the payload mount to secure the payload in place. Ensure they are fully engaged.

3. Connect the payload cable to the corresponding port on the aircraft. Align the connector and push until it clicks, then secure the locking ring if applicable.

To unfold the DJI FLYCART 100 aircraft, follow these steps:

1. Rotate the arm lock to the unlocked position for one of the folded arms.

2. Unfold the arm until it is fully extended.

3. Rotate the arm lock back to the locked position to secure the arm.

4. Repeat this process for all four arms.

5. Unfold the propeller blades on each motor.

6. Ensure all arm locks are in the locked position before installing the batteries.

To install the Intelligent Flight Batteries on the DJI FLYCART 100:

1. With the aircraft unfolded, align the two Intelligent Flight Batteries with the battery compartments on each side of the aircraft.

2. Slide each battery into its compartment until you hear a click, indicating it is locked in place. Ensure the battery release latch is fully engaged.

To avoid signal interference, DO NOT operate other wireless devices at the same frequency as the remote controller for the DJI FLYCART 100.

Yes, the DJI FLYCART 100 aircraft and remote controller require activation before first use. Make sure the remote controller is connected to the internet and follow the instructions in the DJI Delivery App for activation.

To power on the DJI FLYCART 100 remote controller and aircraft, press the power button once, and then immediately press and hold the power button for two seconds.

To start or stop the motors of the DJI FLYCART 100, perform a Combination Stick Command (CSC) by pushing both control sticks to the bottom inner or bottom outer corners simultaneously. Hold this position for two seconds.

Before takeoff with the DJI FLYCART 100, you must always set an appropriate Return-to-Home (RTH) mode and RTH altitude.

To perform an emergency brake and make the DJI FLYCART 100 hover during flight, press the Flight Pause button on the remote controller.

The main components of the DJI FLYCART 100 aircraft are:

1. Front Indicators

2. Rear Indicators

3. Intelligent Flight Battery

4. Vision System

5. Forward Radar

6. LIDAR

7. FPV Camera

8. Downward Radar

9. Spotlight

10. Onboard D-RTK Antennas

The main controls on the DJI FLYCART 100 remote controller are:

1. Back Button

2. Return to Home (RTH) Button

3. Status LED

4. Battery Level LEDs

5. Power Button

6. Flight Pause Button

7. Gimbal Dial

8. Flight Mode Switch