DJI FLYCART 30 A2EWH-30A (01) PDF DOCUMENT

The package for the DJI FLYCART 30 Winch System includes the following items:

Winch System × 1

Winch System Communication Cable × 1

Landing Gear × 2

Landing Gear Extension Rod × 4

Landing Gear Front Rod × 1

Landing Gear Rear Rod × 1

Counter Weight × 1

Cable × 1

Extension Cable × 4

Cable Tubes × 2

Landing Gear Strap × 2

M4×12 Screws × 10

M5×12 Screws × 3

Failure to operate in a safe and responsible manner could result in damage to the product or other property, or even serious injury to yourself or others. Carefully read this entire document and all safety and compliance guidelines provided before use.

1. The DJI FLYCART 30 Winch System is only compatible with the DJI FlyCart 30 aircraft.

2. The winch system requires the use of an extension cable; otherwise, it will affect delivery safety.

3. The maximum payload of the winch system is related to the takeoff weight of the aircraft; DO NOT overload.

4. When connecting the cables, make sure the connection is firm and secure. Operate with caution to avoid damaging the cables.

5. Before usage, check if the hook can be used normally and if the cable can be released and reeled up normally.

6. Operate with caution to avoid injury caused by sharp or moving mechanical parts.

7. When using the winch system, make sure to stay away from the aircraft to avoid injury.

The DJI FlyCart 30 Winch System enables aerial cargo loading and unloading in harsh environments where the aircraft cannot land. After installing the corresponding landing gear, the aircraft is easier to store and transport.

Make sure to follow these steps to install the winch system correctly:

1. Remove the cargo box of the FlyCart 30. First, detach the strap of the cargo box. Then, remove the cargo box. (Figure A)

2. Remove the landing gear and rear radar. (Figure B)

3. Install the provided landing gear of the winch system, extension landing rod, front and back rods. Install the rear radar. (Figure C)

4. Attach the winch system with the M4×12 screws, and connect the winch system communication cable to the payload port of the FlyCart 30. (Figure D)

Old electrical appliances must not be disposed of together with the residual waste but have to be disposed of separately. The disposal at the communal collecting point via private persons is for free. The owner of old appliances is responsible for bringing the appliances to these collecting points or to similar collection points. With this little personal effort, you contribute to recycling valuable raw materials and the treatment of toxic substances.

FCC Compliance Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

ISED Compliance

CAN ICES-003 (A) / NMB-003(A)