TOTALLY WICKED TOUCH (01) PDF Document

If you are familiar with using e-cigarettes, follow the quick start guide below to be vaping in minutes:

1. Prime the atomizer head.

2. Fill the tank.

3. Switch the TOTALLY WICKED TOUCH on by quickly pressing the power button 5 times.

4. Set the power to 12 watts.

5. Press and hold the power button and inhale.

6. Charge the battery (it may not be shipped with a full charge).

It is important to prime a new atomizer head before first use to prevent the coil from overheating or burning. Follow these steps:

1. Unscrew and remove the tank from the battery and invert it.

2. Unscrew the base of the tank.

3. Prime the atomizer head by dripping a few drops of e-liquid into the central hole of the atomizer head.

4. After priming, screw the base back onto the tank, and screw the tank back onto the battery.

5. Note: After priming and filling, it is recommended to wait 5 minutes to ensure the atomizer head is fully saturated with e-liquid.

1. Slide the top cap open by pushing firmly in the direction indicated by the arrow on the top cap to expose the fill hole.

2. Insert the filling nozzle into the fill hole and fill the tank.

3. Be careful to leave an air gap of approximately 2mm at the top.

4. Slide the top cap shut after filling.

5. If you have just installed a new atomizer head, wait 5 minutes before vaping to allow for full saturation.

To switch the TOTALLY WICKED TOUCH on, quickly press the power button five times. The screen will illuminate to indicate the device is active. To switch the device off, quickly press the power button five times again.

Charge the device by connecting the charge port on the battery to a USB port or a suitable wall adaptor using the supplied charging lead. During charging, the battery icon will flash on the screen and the current temperature will be displayed. Once the device reaches 100 percent charge, the icon will stop flashing.

The TOTALLY WICKED TOUCH has an adjustable wattage range of 1 to 80 watts. To adjust the setting:

1. Press the power button 3 times to unlock the left and right touch sensitive adjustment buttons.

2. Tap or hold the left adjustment button to decrease the wattage.

3. Tap or hold the right adjustment button to increase the wattage.

If the device becomes unresponsive, locate the reset button situated below the power button. Use a small pin to press the reset button. The screen will flash momentarily, and normal operation should resume.

To vape, press and hold the power button as you inhale the vapour; a puff timer will be displayed on the screen during this process.

To adjust the airflow, rotate the airflow control ring located on the tank base. Experiment by rotating the ring to find your preferred setting between airy and tight.

To avoid dry hits, ensure the e-liquid level does not drop below the feed holes located on the sides of the atomizer head.

The lifespan of an atomizer head can vary from several days to several weeks depending on wattage, vaping style, and e-liquid type. Indicators that a replacement is needed include:

1. A slight burnt taste.

2. General loss of vapour production.

3. A reduction in flavour intensity.

To replace the head, unscrew the tank base, remove the old head, and follow the priming instructions to install the new one.

The battery unit should be cleaned by wiping it down with a tissue or a dry cloth. Do not submerge the battery in water or allow it to get wet.

The tank can be cleaned by removing it from the battery, unscrewing the base, and removing the atomizer head. The entire tank and base can then be cleaned under hot running water. Allow the tank to dry fully before reassembling. Do not attempt to clean the atomizer head with water.

1. Store the device and its accessories away from children when not in use.

2. Only use the supplied charging cable.

3. Dispose of dead batteries according to local legislation.

4. Do not charge the battery in damp environments or in temperatures below 0 degrees Celsius or above 45 degrees Celsius.

5. Do not use the device in temperatures below -10 degrees Celsius or above 60 degrees Celsius.

6. Do not carry batteries in a pocket or bag with other metallic objects.

7. Do not attempt to repair the battery as it is a sealed unit with no serviceable parts.