TOTALLY WICKED SKOPE S (01) PDF Document

For those familiar with e-cigarettes, the steps below can be followed to allow the device to be used in the shortest possible time:

• Prime the atomizer head

• Fill the tank

• Switch the TOTALLY WICKED SKOPE S on

• Press the power button and inhale

• Charge the battery (it may not have been shipped with a full charge)

To prime the atomizer head, remove the mouthpiece from the tank by unscrewing, then remove the glass section of the tank by pulling upwards. Unscrew the atomizer head and prime by dripping a few drops of e-liquid onto the cotton visible through the sides of the atomizer. After priming, screw the atomizer head back into place, replace the glass section and screw the mouthpiece back on.

Note: Leave a new atomizer head to sit with the tank full of e-liquid for five minutes before vaping. This ensures the atomizer head is fully saturated with e-liquid before use.

It is important to “prime” a new atomizer head before first use. Failure to do so can cause the atomizer coil to overheat, leading to an unpleasant taste and sometimes irreversible damage to the atomizer head requiring early replacement.

Remove the mouthpiece from the tank by unscrewing. Fill the tank with e-liquid, being careful not to overfill and avoid filling down the central airflow hole. Once filled, refit the mouthpiece.

To switch on, quickly press the power button five times; the indicator light will flash three times. Quickly press the power button five times to turn the battery off; the indicator light will flash three times.

Press and hold the power button as you inhale the vapour.

To prevent the atomizer head from becoming dry and burning prematurely, ensure the fluid level does not drop below the fluid feed holes on the atomizer, these can be recognised by the visible parts of cotton on the atomizer.

The TOTALLY WICKED SKOPE S is charged by inserting the USB cable into the charging port. The indicator light will illuminate red while charging. Once fully charged, the red indicator light will switch off.

To replace the atomizer head, follow the steps outlined in “Priming the Atomizer Head” to remove and separate the tank. Prime your new atomizer head and reassemble.

This indicates Short Circuit Protection. If an atomizer short circuit occurs, the indicator light will flash three times and the TOTALLY WICKED SKOPE S will switch off. Replace the atomizer head and charge the battery to restore power to allow normal operation to resume.

This indicates No Atomizer Detected. If no atomizer head is detected when the power button is pressed, the indicator light will flash continuously until the power button is released. If this happens, ensure the atomizer head is properly fitted, referring to appropriate instructions above.

This indicates Atomizer Head Protection. If the power button is held down for longer than 15 seconds while vaping, the indicator light will flash eight times and the TOTALLY WICKED SKOPE S will switch off. Release the power button and charge the battery to restore power and allow normal operation to resume.

1 x TOTALLY WICKED SKOPE S

2 x BFHN 0.5ohm atomizer heads

3 x Silicone rings

1 x USB cable

1 x User manual

• Store the TOTALLY WICKED SKOPE S and its accessories away from children when not in use.

• Please only use the charging cable provided.

• Please dispose of dead batteries in accordance with your country’s appropriate legislation.

• Do not charge the battery in a damp environment, or in temperatures under 0°C or above 45°C.

• Do not use the device in temperatures under -10°C or above 60°C.

• Do not carry batteries in a pocket or bag with other metallic objects.

• Do not attempt to repair a faulty TOTALLY WICKED SKOPE S battery as these are sealed units with no serviceable parts. Attempted repairs will void the warranty.