LELO SMART WAND 2 MEDIUM (01) PDF Document

The LELO SMART WAND 2 MEDIUM is locked for transportation. To unlock it, you can simply connect the charger, or press and hold the + and – buttons simultaneously for 3 seconds until the light turns on.

Before the first use, you should charge your LELO SMART WAND 2 MEDIUM for 2 hours. Insert the DC plug into the DC port located at the base of the device. The LED on the interface will pulse to indicate that the device is charging. Once it is fully charged, which takes approximately 1.5 hours, the LED will emit a steady glow. Only use original chargers provided by LELO with your device.

Press the + button to turn the device on; pressing it again will increase the vibration strength.

Press the ( ) button to switch between the 10 different vibration patterns.

Press the – button to reduce the vibration strength.

Press and hold the ( ) button to turn the device off.

For the most pleasurable sensation, you can apply a liberal amount of LELO Personal Moisturizer to your body and to the LELO SMART WAND 2 MEDIUM before and during use.

The LELO SMART WAND 2 MEDIUM is fully waterproof, which makes cleaning simple. You should clean the device thoroughly before and after each use. Rinse and spray the device with LELO Toy Cleaner, then rinse again and allow it to dry. Alternatively, you can wash the silicone with warm water and antibacterial soap, rinse with clean hot water, and pat dry with a lint-free cloth or towel.

Never use cleansers that contain alcohol, petrol, or acetone. Avoid using the device with hand creams or silicone-based lubricants, as these may make the silicone permanently tacky.

Avoid leaving the LELO SMART WAND 2 MEDIUM in direct sunlight and never expose it to extreme heat. It should be stored in a dust-free place and kept away from products made of other materials.

The appliance is for adult use only and children shall not play with it. Individuals who are pregnant, or those who have a pacemaker, diabetes, phlebitis, thrombosis, or any other medical condition, should consult a medical professional regarding the risk of blood clots before using any personal massage product.

If the LED does not pulse when the charger is connected, the battery may be completely drained and will require several minutes to acknowledge the charge. Also, ensure the charger is properly connected to both the wall and the DC socket.

If the LELO SMART WAND 2 MEDIUM does not activate when the center button is pressed, the battery may be empty and require recharging. Alternatively, the interface might be locked; to unlock it, hold down the + and – buttons for 5 seconds.

The specifications for the LELO SMART WAND 2 MEDIUM are as follows:

When the battery is running low, the LED on the interface of the LELO SMART WAND 2 MEDIUM will emit a blinking white light.